It needs a new multi-function switch, or ear plugs.
Try rescanning the set. Did the antenna get turned to a wrong direction?
The rabbit antenna needs to be turned the right direction and have the two elements spread to collect enough RF signal. Powered antennas are best in some cases, that is ones that plug in to the ac wall socket. Also check the cable connection into the tv set antenna connector.
Many television stations have been using digital signals for at least 30 years. They turned them into analog signals at the antenna for broadcast. Now they are simply leaving them in their original form.
His daughter turned him in.
You Turned the Tables on Me was created in 1936.
multi switch on steering coloum is wearing out
broken turn signal switch assemblyreplace it
The cause for a turn signal flasher to keep clicking on a 1999 GMC Jimmy is a bad flasher unit. Replacing this with a new flasher unit should solve this problem.
An intermittent connection would be a connection that is not constant. For example, if you have a light in your house that you have turned on and it flickers on and of, that would be intermittent, not constant light.
probably have a bad relay, that was my problem.. Are your turn signals not working, but your hazards lights are? and if so, do you hear a constant clicking sound, like your turn signal is turned on? Does the clicking sound go away when you hit the brakes? It is the relay.
Your flasher relay box may need to be replaced, but could also be an electrical short.
The sound you are hearing is a relay clicking on and off. If your turn signals work fine then its probably not that one. While you can hear the clicking remove the relays one by one until the sound stops and that will tell you which system is affected. In my case the low and intermittent setting for my wipers did not work and the switch was turned on without my noticing it so the wiper relay clicked constantly without the wipers going. I did not realize that it was the problem until I bumped the switch into the proper off position and the sound stopped.
Flasher is under the dash, drivers side, follow the clicking sound the signal makes when turned on. That sound comes from the flasher. If signal is staying on it could be you have a bulb or two out. Check your signal lights before replacing the flasher.
The "park" signal on the wiper motor is off. The wipers should stay off their cradles about an inch or so. If the ignition key is turned off during an intermittent wipe, the blades may stay at some position on the windshield. They'll return as soon as the next cycle comes up after the ignition is turned on. If they do not behave this way, you likely have a bad wiper motor assembly, which has the control circuit that parks the blades.
Replace the switch under the hazard button on the dash.
Turn signal bulbs and hazard bulbs are the same bulb. When the turn signal is turned on, the indicator light on the dash flashes in tune with the turn signal. When the hazard lights are turned on, an extra fuse which is live, powers the hazard flashers, even if the car is turned off.
central airconditioner makes a clicking noise when running? any idea what to check?