The "park" signal on the wiper motor is off. The wipers should stay off their cradles about an inch or so. If the ignition key is turned off during an intermittent wipe, the blades may stay at some position on the windshield. They'll return as soon as the next cycle comes up after the ignition is turned on. If they do not behave this way, you likely have a bad wiper motor assembly, which has the control circuit that parks the blades.
The first position of the wiper stalk on my 306, is the 'intermittent' or auto position. The second is continuous slow, and the top position is continuous fast. If these do not work, then the stalk is broken!
The car wipers should not stay up but return to their original position. The wipers will stay up if the wiper motor, the wiper controller and the wiper linkage are faulty.
A bad pulse board or window wiper motor can cause your wipers to stay in the "up" position.
The motor shaft and the wipers are'nt connected properly(the timing is off), just disconnect the wipers from the motor. Turn your car on and cycle the motor and it should be back at the home position. Pull your wipers back down and reconnect and all should be fine.Thats if you put in a new wipermotor. If not, maybe the wiper switch is bad.
why is it after I hooked up the linkage for my wipers the wipers stay in the upright position after I turn them off.
cycle next to a friend and stay the dictance apart.Your paths are
It stands for intermittent needle therapy. It is a peripheral intravenous access site used to administer medications. It remains in the hospitalized client during their entire stay, in case emergency access is needed.
Check your fuses. The wiper fuse may be blown.
remove wiper arms from vehicleturn wipers onthen turn wipers offshut off ignitionreplace wiper arms at the down positionthis should be the return position when ever u shut wipers off
You can detailed instructions on how to reset your wipers on youtube.com/watch?v=KFBLtlnkpuI
wiper motor could be going bad
1997 gran prix wipe stay in upright possission when shut how to fix