How do you change the factory radio in a 1991 Buick regal?

Answer 1

This involves removing the dash panel, and is very complicated and time-consuming. 1. Using a flat screwdriver (or another appropriate tool) pry off wooden and black decorative plastic panels from the dash board. 2. Remove dash vents. 3. Unscrew all dash bolts (do not forget the two bolts facing downwards behind the steering wheel, on top of speedometer and tachometer, and the bolts behind each vent). 5. Remove panels. 6. Now you can unscrew 3 bolts holding the car radio. 7. Pull it out and disconnect the wires from the back.

You will need a flat, phillips and a trox screwdriver.

Answer 2

There are aftermarket kits available to install a standard single din stereo where the remote cassette or CD player resides now. Hope this helps. Pat

AnswerItem #120701858L this wiring harnesses will allow you to install an aftermarket head unit without cutting factory wires.Item #120992020 This will provide the proper support to mount the new head unit where the casset player is mounted.

Item numbers apply to www.crutchfield.comThey also included one of their "master Sheets" with my order for free which gives step by step instructions and illistrations on installing after market equipment on a Buick regal.

Answer 3

Go to your climate control system. locate the black bezel that surrounds it. You should be able to pry it off with just your fingers, but if you can't use a small flathead screwdriver. Once you get that bezel off, you should see four torx head screws. Take these out. This will allow you to take out the large bezel that surrounds the radio and climate control unit. Starting at the climate control side, pull the bezel toward you and out to the driver's side. Now you can get to the four torx screws holding the radio in place. Assembly is the reverse. Go to your climate control system. locate the black bezel that surrounds it. You should be able to pry it off with just your fingers, but if you can't use a small flathead screwdriver. Once you get that bezel off, you should see four torx head screws. Take these out. This will allow you to take out the large bezel that surrounds the radio and climate control unit. Starting at the climate control side, pull the bezel toward you and out to the driver's side. Now you can get to the four torx screws holding the radio in place. Assembly is the reverse.

Answer 4

You will need to go to a dealership and get from them some type of code number for that year regal. Trust me i did the same thing. Let me guess you replaced a battery possibly or one of its cables? They will give you this code for no charge. I keep mine on the last page of the owners manual now

Answer 5

Well it depends if it's an old Skylark or a new one. In any event, they're easy. If you have the old kind with shafts, just take the knobs off and use a socket wrench to remove the nuts holding the radio on. The new radios have two small nuts just underneath the front of the radio, right above the console. You should use a tiny adjustable wrench to get at it. It's very easy to reinstall. Try Crutchfield.com. They have plenty of installation information.

Answer 6

== ==