The headlight assembly is held in with four bolts: two on the top, one underneath, and one that connects the headlight assy to the turn signal assy. The frame can be removed from the headlight by carefully prying at the adjustment pins. Complete information is on page 351-3 of the Official Saab 900 Manual by Robert Bentley Publishing, which every Saab owner should own.
Ignore that previous answer, he probably thought of removing the clear lens from the black housing... Yes, you can replace the headlight cover. The assembly is just pushed into three ball snaps. First from the engine compartment unscrew the bulb and pull it out, second with two thin pry bars lightly pop out the assembly, it its only as big as the lens squared, They can be purchased as a new headlight assembly (which is just the one lens with the black plastic inner shroud the bulb screws into.) Once you have it out it will appear so simple and just snap back into place the new one and screw in the bulb. I bought two new ones on EBay for $20.
Th ee headlight lens is not removable separately. The assembly is held in by screws on top, and clips on the rear.
Pop hood. There is a torx head visible from the top at the edge of the fender--believe its like a T-20 or T-25. The second one is a bit more difficult---gonna have to slide the torx head screwdriver between the marker (side) lens and the turn signal at the front of the vehicle. There is another torx screw, same size, in there. once removed, just pull out the lens. Install is reverse.
Green or Grey lens, B-15 Brown lens
Open the hood and you can get behind it with a long screwdriver. Simply pop it toward you by prying with the screwdriver. You'll see that it is simply mounted on 3 metal ball tipped shafts that press into the plastic housing. For installation, lubricate the 3 plastic mounting points with spit or some other lubricant and knock it back on with your fist at each of the 3 points. Yer welcome!
how to change the headlight lens on a grangcherokee jeep
i have dropted the bulb into the headlight and i want to remove the lens to get it out any ideas thanks
you need to remove the bumper to access the 2 10mm bolts of the headlight
You don't. Instead, you replace the entire assembly.
four steps remove front grille plastic rivets push in remove indicator lens it slids unbolt headlight unit bolts again slids out just tip up as its almost out remove metal clips round lens little screw driver will do then reverse directions
unplug the bulb, then remove the metal clips on front of headlight that secure it to the grill. pull the headlight straight out of the front of the grill. This is the best way to change the bulb as well.
how to replace the headlight
If you want to remove the BMW headlight lens simply follow the user manual.
Actually.. to take the headlight lens apart, put the Oven on 200, put the headlight assembly in oven for a few minutes at a time, as the headlight assy heats up, the adhesive will loosen up making it easy to remove the lens. For a demonstration, go to Youtube and type in "How to remove headlight lens from assembly"
After you take the headlight out, remove the metal clips holding the lens on. The lens has to be pried off because there is silicone there to keep it together
Yes
If this is a Camry,and the headlight lens is broken,you would have to buy the whole assembly,not just a lens. If the headlight lens is discolored[being that it is plastic]there are products to make them clear. Go to E-bay motors and look up headlamp cleaners..A good product..........