Bent or restricted track?
Broken cable?
This may not work for everyone but on my 2000 Jeep Grand Cherokee Laredo, we moved the seat all the way forward for cleaning and the power seat stuck there. I could move it about a half inch backwards and forwards, so i knew the motor was functioning properly. I took out the four bolts which secure the seat to the car body and tilted the entire seat assembly backward so I could get a better look underneath. I did not disconnect any electrical components.
When I tested it again, in the tilted position it suddenly began to move through it's full range, forward and back. I thought maybe something that was jamming the track had slid out when I tilted it but now that it is secure I can hear some clicking from the assembly. So it wasn't a 100% fix, but at least it freed the seat up
Look on the left side of a 93 Grand Cherokee. It will be the front one.
How to change the brake switch on a 2004 Jeep grand Cherokee Laredo
It is not equipped with a fuel switch.
It is part of the latch.
Listed on the drivers door post.
The 1993 Jeep grand Cherokee brake light switch simply plugs in and out. The brake light switch is located beneath the dashboard on the drivers side of the engine compartment.
it should, 93 - 98 are the same
Look on the left side of a 93 Grand Cherokee. It will be the front one.
The fog lamps are activated on a 2000 Grand Cherokee via the headlight switch. Pull the END of the lever OUT.
Yes.
bad switch, bad motor, bad ground?
You will have no problem with that switch over.
How to change the brake switch on a 2004 Jeep grand Cherokee Laredo
It is not equipped with a fuel switch.
Press the Button...
under the dash on the drivers side
drivers side rear behind bumper