You need to press the source button (SRC) until you are in the Standby mode. Once you do that, just press and hold the menu button until the menu pops up. Then just cycle through the options until the AUX option comes on.
The radio will work fine, but there will be nothing to hear.
Only if you want the radio to work.
I was wondering the same thing. Does anyone know if changing your am/fm/cd selector switch to a 4 position switch (the 4th being aux. input) would work? Yes you can add auxiliary audio input to any stereo but you will need to solder a 5 pin aux 3.5 jack into the radio board before the radio preamp after the FM output, there are 2 cables for audio in 2 cables for audio out and 1 for ground, when you insert the headphone style jack the 5 pin aux jack will stop the audio from the FM and play the audio from the external source
I work an early morning shift as News Director as well as side-man to morning host.
The radio waves don't follow the car when it is moving fast.
The Kenwood KDCHD942U works with normal radio signals. Most radio stations have switched to HD transmission, like Television broadcast stations.
yesgo to walmart and buy a plug kit
It was difficult to find the answer to this question. The vintage Kenwood radio does come in a mahogany wood cabinet. It will probably need to be refurbished but there are people who still do this type of work.
Henry Richard Kenwood has written: 'Public health laboratory work'
Not for a shark radio. If you buy a main brand radio, Alpine, Pioneer, Sony or Kenwood you can get adaptors to allow you to use your steering wheel controls and get your LCD working again. The leads are about
This may involve a problem with fuze #10, a 10 amp fuze, which services some sort of controller along with a auxiliary heater water pump. Normally, if this fuze doesn't work, when you drive the car the radio won't work, the inside courtesy lights won't work, and the ability to "flick" your high beam won't work. Various sources indicate that often the auxiliary heater water pump is defective which causes the fuze to blow. If the fuze is good, then there is something else happing.
I just got one for a stereo I bought off a guy and it is a kenwood, so I went to kenwooc.com and downloaded it for free. Maybe it will work for your stereo. Good Luck.
Your best bet would be to find the CD changer the same as the brand of your radio. Such as Kenwood radio, get a kenwood CD changer. The factory CD changer will not work with most newer radios installed. And unless you like running wires to the back of your SUV it would save you lots of time to get another CD changer. That is what I did and it works just fine.
Both are in the left hand lower dash fuse panel, one is Radio or RDO, and the other is CIG or DOME, all must work for the radio to Function. Relentless
The auxiliary contact is to be utilized for interlocking of another relay or contactor or indication signal from another equipment.
I found the answer - the wiring harness you can buy to connect from SONY to TOYOTA had a missing wire - it can be fixed by swapping another wire in the wiring harness over
we need a form for a fire company auxiliary new members also what are the duties of a auxiliary can they also work for the community.