Unbolt tire, pull out cotter pin at end of axle, break nut loose on the end of the shaft. (you might need to put tire back on and lower \truck back down so tire wont rotated when doing this)unbolt the brake caliper, take off rotor, unbolt three bolts from the hub. Use a old socket to hold on the lossened bolts and pound on the bolt heads until the hub till loosens up and falls off. You might need a chisle to wedge in there. pull shaft out.
Check the front driveshaft.
The thermostat on a 1996 Jeep Cherokee is under the housing where the upper radiator hose attaches to the engine.
Yes
1985-1996 Jeep Cherokee XJ should interchange 1997-2001 Jeep Cherokee XJ should interchange
The 1996 will not have a hole in the rear of the head for the gauges coolant temp sender.
Check the front driveshaft.
no but there is no point to remove it, it will not help your gas mileage that is a myth
No.
The universal joints in the front driveshaft may be going bad.
You have to remove the driveshaft to flat tow a 2wd Jeep.You have to remove the driveshaft to flat tow a 2wd Jeep.
throw a rock at it
Yes
Yes it will.
Where is the windshield wiper relay located on a 1996 grand jeep Cherokee
The ajustment bolt for the belt is under the power steering pump.
No. They are not interchangeable.
yes it should