If you are referring to the factory supplied radio, it is not a 'component' type radio. It must be removed from the dash and dis-assembled.
Remove the 1993 Toyota decorative radio cover in. Remove the radio retaining screws. Pull the radio out. Remove the wiring harness.
I'm not sure if this helps you but please check it out: http://www.installdr.com/InstallDocs/Honda/PDF/466053.pdf
* Remove the ashtray and ashtray holder * Remove the radio and mounting plate screws and lower the radio and unplug the electrical connector and antenna lead then push the radio out of the dashboard
Begin by removing the decorative cover from your 2001 Pontiac Bonneville radio. Remove the radio retaining screws. Slide the radio out and remove the wiring harness and the antenna cable.
you can't do it yourself you have to get help from a pro
Begin by removing the decorative cover from your 1990 Chevy Caprice factory radio. Remove the radio retaining screws. Remove the wiring harness and the antenna cable from the back of the radio.
Remove the retaining cover to your 2005 Chevy Malibu radio. Remove the radio retaining screws. Slide the radio out. Remove the wiring harness and the antenna cable.
Remove the 1993 Toyota decorative radio cover in. Remove the radio retaining screws. Pull the radio out. Remove the wiring harness.
See these instructions http://integrationsolutions.net/AUX_INPUT/BLITZSAFE/HON_DMXV2X/RRI/ODYSSEY_replace_rri.html
Visit the site, below in the related links and sources for more information and help.
To install a factory radio in a 2007 Honda S2000, first, disconnect the negative battery terminal to ensure safety. Then, carefully remove the center console trim using a trim removal tool to access the radio. Unscrew the existing radio, disconnect the wiring harness and antenna, and then connect the new factory radio by reversing the disconnection process. Finally, secure the radio, reattach the trim, and reconnect the battery.
Honda radioremoving Honda radio installing sony radio
Factory reset for a radio in a 1999 Honda Accord can be done by a dealership. The requirements from the dealership to have this done is proof of vehicle ownership.
no there are no factory radio that has RCA.s except the new tiburon with factory kenwoods in them
how do i remove the radio on the 96 Honda odyssey
To remove the factory-installed radio from a 2002 Honda Civic, start by disconnecting the negative battery terminal to ensure safety. Use a flathead screwdriver or a panel removal tool to carefully pry off the trim panel surrounding the radio. Once the trim is removed, unscrew the radio mounting screws, then gently pull the radio out from the dash. Finally, disconnect the wiring harness and antenna cable from the back of the radio to complete the removal.
How to remove the factory radio and disconnect wirring harnes in a 2004 f150 ford truck