I have been trying to do that a while ago as someone told me there to just take the clips off with a flat head screwdriver
however, it didnt work but underneath the wheel there are small screws that u need to remove or something, i have a feeling the answer is there.
Basically what I know is that if you manage to remove that big wood cover, you will be able to remove the radio easily and I have a feeling that the big cover is attached to the pad under the wheel.
Hope i helped
there are about 5 screws, these have the wierd star heads on them so you need the right screw driver. All the way to the left on the wood cover you'll find one in the AC vent. Just turn it so you see the screw head or remove the moving vent (turn and pull out). Two more above the dash, bring steering wheel all the way down for easier access, same size on all screws. Pull cover above radio (all across the top of the radio). where you'll find one or two more.
pull wooden cover off and you'll see the radio exposed. Underneath the radio are two nuts that you'll have to loosen but not all the way off. pull radio out.
two large connectors on the back plus the antenna wire
goes back in reverse order....
you have to carefully pry the bezel plastic away from the vents at the top. (the black trim surrounding the vents and the hazards button.) Once the bezel is off you must pull with some force, straight backwards and the vents and button housing unplug from their clips allowing you access to unplug the electronics from the hazard button. Remove the two number ten bolts holding the stereo brackets in place, and move down to remove the knobs then the bezel/face from the A/C and heater controls.
somehow I am supposed to remove the heater and the radio as they are all connected to the same bracket. I have been researchinga nd found this pdf... it helps me...there are two more screws beneath the heater&A/C control board. ..probably need to remove the ashtray...
anyway hope this helps you... and me for that matter. I'm going to try it now.
Link:
http://www.justanswer.com/uploads/skyvisions/2008-12-28_151602_01_avalon.pdf
Remove the radio and check to see that the connectors are plugged in to the back of the radio.if they are connected then it may be a bad radio.
Remove the 1993 Toyota decorative radio cover in. Remove the radio retaining screws. Pull the radio out. Remove the wiring harness.
Attached in the links below are diagrams for the factory radio and the related dash panels to remove it. I've also posted some additional links for future reference.
Radio Roo was created in 1991.
Begin by removing the decorative cover from your 2001 Pontiac Bonneville radio. Remove the radio retaining screws. Slide the radio out and remove the wiring harness and the antenna cable.
Remove the decorative cover from your Cadillac Eldorado radio. Remove the radio retaining screws. The radio will slide out. Remove the wiring harness and the antenna cable from the back of the radio.
Remove steering wheel and signal switch
Eldorado Gold was created in 1991.
get a manual on your car from DISCOUNTAUTOREPAIRMNUALS.COM and it will help on the next repair also.Plus it has pictures.
Remove the " Radio 'vent screen' " by poping it out, remove the screws ( 2 or 3 )l, then on the underside 'across the top, remove screws ( 3 or 4 ) from Radio over toward the left, then 'whole panel' across can be removed.
How to change radiator on 94 eldorado
To reset the service CCR light on a 1991 Eldorado, disconnect the battery for 10 minutes. Reconnect it and start the car.
You can find it on 12volt.com
R12
http://tonygspotmusic.googlepages.com/bigbrian
How hard is it to remove and is there a digram procedure available on-line to remove it.
The ECU is located behind the radio remove radio look in that box back there is the ECU to remove it take out panels on both sides of front console remove radio remove screws holding ecu carefully remove clips and pull ecu out passenger side. You dont need to pull the stereo.