Take key and insert in back hatch lock and turn. That should reset as I had the same problem.
NoNo
It means that the theft computer has detected a malfunction and set a trouble code.
Compressor will normally run when in defrost mode.
A programmed RKE fob (remote) or a chipped key is required.
To reset limp mode on a Polaris vehicle, first, ensure that the underlying issue causing the limp mode is resolved. This often involves checking for error codes using a diagnostic tool and addressing any mechanical or electrical problems. Once the issue is fixed, turn off the ignition for a few minutes and then restart the vehicle. This should reset the limp mode, allowing normal operation to resume.
Jeep does not have reset buttons.
NoNo
As it is a DOS game, all you have to do is restart in MS-DOS mode to play it.
hi Try turning off your computer at the mains and then restart it hopefully then it should come of hibernation mode
no but you can start a new game on another save file
In order to deactivate theft mode on a Ford Windstar, the key has to be programmed to do so. If you have the original key, you need to call Ford and they will do it for you.
its always in theft mode. There should be a little light that will flash on the dash or around the speedometer when the ignition is off and the key is out.
* What does the computer do when you attempt to boot it up? * What operating system? The computer would just shut down completely after selecting 'restart.' No problems booting up thereafter. I have Windows XP Service Pack 2. I have determined what the problem was. It was due to enabled software called Window Washer 5.0. When I disabled it, my computer is now able to go into restart mode.
Yes when you do prestige mode it restarts your create a class and your weapons.
can you be more specific?are your high beams flashing? this means your jeep has anti theft. if you don't have the remote you can shut it off by inserting your key into the drivers door and first locking and then unlocking the door.do any other electronics work? lights? radio?check the fuse you replaced. is it the proper rating? did any other fuses go out?
i do not no
Please restart the computer and press F8 for Safe Mode. See if there is an Administrator account you can access. Let me know and we will go further.