answersLogoWhite

0

It depends on how it is attached...

User Avatar

Wiki User

13y ago

What else can I help you with?

Continue Learning about Music & Radio

Can you take out guitar strings out just to clean the Guitar then put them back?

generally no if you take off guitar strings after they have been on there for a while and tuned they would have stretched so if you take them off they will lose there tension and you will have trouble tuning your guitar so its best just to clean your guitar when you need to change the strings


How do you attach a whammy bar to an SG guitar?

Only some electric guitars can have a whammy bar attached. On the side of the bridge (the bridge is the part that has the strings attached to it on the bottom half of the guitar) locate a small hole. Put the part of the bar with the twist on/off bit in the hole and tighten it. Don't push down too hard on the bar, as it may damage the bridge/body of the guitar. When putting the guitar in a bag or case, remove the whammy bar.


What are some general problems with guitar capos?

Tuning, bent strings, distracting, hard to tighten/take off, gets in way of playing, damages guitar, etc.... i hate my capo


How can you make custom, homemade guitar picks?

You can take an old jacket and take the zipper off and you have to make sure its big enough and pait it or glue some stuff to it make it your own


How do you fix onoff switch on guitar amps?

Open up your amp and see if there is loose wiring on your on/off switch. If so, you can take a soldering iron and fix it. If that doesn't work, or that's not the problem, then you can take it in to a guitar shop for a replacement switch, which will only cost you around $10.

Related Questions

Is glueing on a guitar strap bad for the guitar?

Its not really bad for the guitar but if you want to take it off or you want to sell it or something like that i would not recommend it


How does a strap lock mechanism work?

Strap locks work by means of a washer. A washer is placed in the narrow, tapered end of the strap button. The wide, outside tapered end of the strap then prevents the washer from slipping, as it is screwed tight.


Is duct taping a guitar strap bad for the guitar?

it generally depends on the material that the guitar is made of if it has paint on it the tape could tear the paint if you are looking for a strap that wont fall off go to the "planet wave" web site they make straps that clip onto your guitar


How do you beat level 3 in factory balls?

you start off by dipping the ball in blue you then put on the thin strap, then color it purple, take off the thin strap and replace it with the big strap then die it blue, take off the big strap and your done! 😄


How do you reset guitar on Guitar Hero?

Some of the guitars have reset switches. If it does not have one you can unplug the guitar from your gaming system and take out the batteries. The controller should reset itself once you put the batteries back into it. The controller also resets if anytime you turn the system on and off while the guitar is on and attached.


How do you get starter off 1990 Trail Boss 250 Polaris?

I have worked on a 98 trail boss. You have to take off the fly wheel cover/recoil first. After that there are two or three bolts that will come out of the starter. there is a ground strap that is attached to the starter that needs to come off also.


Can you take out guitar strings out just to clean the Guitar then put them back?

generally no if you take off guitar strings after they have been on there for a while and tuned they would have stretched so if you take them off they will lose there tension and you will have trouble tuning your guitar so its best just to clean your guitar when you need to change the strings


How do you take a Wii strap off a Wii remote?

you have to slide the square thing to your wrist


Is it okay to take off a fingerplate on an acoustic guitar?

Yes. You should already have it off!


Why does sonic never take off his shoes?

there attached to his feet


What will happen if you take a dc coil off its armature?

It will no longer be attached!


How do you complete factory balls two level 19?

you start off by dipping the ball in blue you then put on the thin strap, then color it purple, take off the thin strap and replace it with the big strap then die it blue, take off the big strap and your done! 😄