you don't tighten a serpentine belt the tension is supplied by a tension pulley if belt is loose, it is time to replace belt or tension pully if tension pully needs repplacing belt will be worn anyway
I dont have the answer, but my 92 does the same thing
To remove and reinstall the Serpentine Belt on 1995 Grand Cherokee I just replaced the alternator in my 1995 Jeep Grand Cherokee. There are two bolts on the back side of the power steering pump. These have to loosened up first. There is also a tensioner bolt underneath this same area. Make sure you loosen the bolts on back of the PS pump first. What I did to reinstall the serpentine belt was to mark the bolt on the tensioner to make sure I got it back to the same place, then let out the tensioner bolt until I could slip the serpentine belt on. (Note: Make sure you follow the diagram inside the engine compartment on top of the radiator shield when reinstalling the belt or else you may install it wrong and may damage the water pump.) After installing the serpentine belt (again, make sure you have it on right) you have to tighten up the tensioner bolt, then tighten up the two bolts on the back of the PS pump. It says in the Hayes Manual to use a tension gauge to get the right tension on the belt. There are good instructions in the Hayes Manual for the Jeep Grand Cherokee.
There is no idle pulley on 1995 GC's with 4.0 Inline 6. To replece the serpentine belt; 1) Draw a diagram of the existing routing. 2) Loosen the alternator. 3)Remove old belt and compare to the new belt. 4) Install new belt. 5) Tighten new belt by tightening alternator. on the 5.2 and 5.6 just rotate tension pulley to the right if you are standing in front of Jeep install and release the tension pulley and let it tighten
Yes, the frame is integrated into the body.
nissan altima, 1995
How do you reset the security system 1995 Nissan Sentra?
The starter relay on a 1995 Nissan Sentra is called the Ignition Relay. It is located on the fender wall in the engine compartment behind the battery.
The speed sensor is in the engine compartment on a 1995 Nissan Sentra GXE automatic transmission. It is on the back of the transmission.
I have a 1995 Nissan sentra and the brake lights were stuck on because of a switch that broke above the brake. the mechanic said it happens to alot nissans
It should have a spring loaded automatic tensioner, if the spring is broke replace the tensioner arm assembly
bottom of the radiator
The thermostat on a 1995 Nissan Sentra 1.6 is located behind the water inlet. The water inlet is positioned at the end of the lower radiator hose.
1342 couter- clockwise
no its part of the starter i belive
The thermostat on a 1995 Nissan Sentra 1.6 is located behind the water inlet. The water inlet is positioned at the end of the lower radiator hose.
It is on driver side top of firewall right behind strut
Call an auto parts store. They have the info.