answersLogoWhite

0

The connector has a latch/lock on it that needs to be slid over before it can be unplugged. On my Jeep the lock was red and I just sort of pulled the bigger side with my fingernail, since it is kind of small and harder to get, until it wouldn't move anymore and presto I could then just pull the connector loose like any normal plug. Hope this helps.

User Avatar

Wiki User

18y ago

What else can I help you with?

Related Questions

Thermostat on a Jeep Grand Cherokee v6?

On a Jeep Grand Cherokee v6, the thermostat is located in the thermostat housing. The housing can be easily located by following the upper radiator hose to it.


Where is a bell housing on a 1999 grand Cherokee Laredo?

The bell housing is between the engine and the transmission.


Where is the thermostat located in a 1999 Jeep Cherokee Sport?

On a Cherokee the thermostat is under the housing that the upper radiator hose hooks to. On a Grand Cherokee with the 4.7L it is under the lower hose attachment housing.


Where is the diagnostic connector on a 1997 Jeep Grand Cherokee?

under the dash right hand side.


Where can you find the Crankshaft position sensor on your 2000 3.1TD Grand Cherokee Limited?

behind engine , on top of transmission housing , slightly to the right side.There is some 30cm of cable attached to sensor and than a connector to instalation.


Where is the crankshaft position sensor on a 1996 jeep grand cherokee?

The crankshaft position sensor is bolted to the bell housing of a 96 Grand Cherokee. It is at the top of the bell housing, just on the drivers side on a 4.0 L and on the passenger side on a V8.


Where is the crankshaft sensor on a 2001 Jeep Grand Cherokee 4.0L?

The crankshaft sensor on a 4.0L Jeep Grand Cherokee is mounted on the top driver side of the transmission bell housing.


What is the location of the thermostat on a 1995 grand Cherokee?

It is under the housing where the upper hose goes on the engine.


Where is the HVAC housing located in 2003 Jeep Grand Cherokee?

It is under the dash, inside the car.


Where is the crankshaft sensor located on a 1994 Jeep Grand Cherokee?

It goes into the top of bell housing.


Where is jeep grand Cherokee 1996 obd or obd2?

The OBDII connector is under the dash on the left (driver) side.


94 Jeep Grand Cherokee front turn signal?

To replace a turn signal on a 1994 Jeep Grand Cherokee prop the hood open. Locate the headlight housing and the turn signal will be located next to it. Find the bulb and remove it from the housing. Replace the bulb.