Want this question answered?
ferrule or ferule
you need to attach a wire to the steel frame of the turn table, maybe a screw that's into metal not plastic on the frame of body of the turntable. then connect the wire to the ground terminal on your amp, the terminal should be marked.
i don't believe you can prevent it... just do it alot and your voice should get used to it... like mine =]
If you installed it yourself..... check to see if you blew any fuses under the dash first. If it's not that your probably grounding out on something. Either the back of the speaker touching metal or a split cable touching metal somewhere. That's the most common problems I've run into anyway, Good Luck.
That sometimes happens when there is a cable or wire that is not shielded correctly (That outside metal mesh in the wire) or bad grounding of the equipment. Bad ground can also give you quite a shock. This may not necessarily be the wah. The Wah may just be helping to raise the volume of the radio signal.
No, but the frame of a metal house must be grounded to an approved grounding electrode.
hmm not sure what grounding wires your talking about but most wires bolted to metal are ground wires
grounding is when you put it on something metal. while discharging is taking away somethings electric current
is it permitted to use flexible metal conduit over 6 ft in length as a grounding means
The 'welding sparks' that come off during welding are metal particles from the filler metal, electrode, or base metal that are lost during welding. The standard term is spatter.
Any bare metal part
Electrolyte plates in a grounding system are electrically grounded metal plates on which a person stands to discharge static electricity picked up by his body. This is called grounding.
The sparks are created from the rapid oxidation of small particles of reactive elements.
By grounding them in the earth. In a home, grounding is typically done by tying onto a large metal (usually copper) water pipe.
Normally the fixtures come with a grounding screw that you attach the grounding wire to. If the box you attaching the fixture to is metal and there is no grounding wire present then the grounded conduit should ground you fixture.
Metal track and metal wheels.
Sparks Fly