Im studying this for school. Need to know how long it takes to make a Hub for minting coins? Im studying this for school. Need to know how long it takes to make a Hub for minting coins? Im studying this for school. Need to know how long it takes to make a Hub for minting coins? Im studying this for school. Need to know how long it takes to make a Hub for minting coins? Im studying this for school. Need to know how long it takes to make a Hub for minting coins? Im studying this for school. Need to know how long it takes to make a Hub for minting coins? Im studying this for school. Need to know how long it takes to make a Hub for minting coins?
It takes one week to make jelly-beans! A whole week!
So it could take a year or a couple of mounths or week depending how long you take on it.
4,500 years
2 seconds
About 1,600 years
30 years at the least.
take hub assembly off vehicle inspect and fix damage seals, bearing, exc.
how long does it take to make a crayons
remove the 2 bolts holding caliper to spindle and . then take rotor an hub from spindle u take a hammer and hit the hub between studs and make sure u dont hit them. this will break rust loose from rotor an allow u to use a chisle to get hub and rotor to seperate...make sure that u remove hub and rotor from car first
u take a hammer and hit the hub between studs and make sure u dont hit them. this will break rust loose from rotor an allow u to use a chisle to get hub and rotor to seperate...make sure that u remove hub and rotor from car first
With the proper tools and knowledge, 1 hour.
i got whole spindle on in less than hour and half
A freewheel hub dose not make the pedals go forward when the backwheel is turning, a track hub dose.
As long as you make it take.
how long did it take colonial chandlers to make candles
Take off the wheel and the brakes. There should be a cap in the center of the hub, take that off. There will be a nut with a cotter pin through it, take out the cotter pin. Unscrew the nut, take out washer. Slide hub off spindle. Knock the back seal out of the hub. Clean the hub, pack bearings and hub with grease. Place new back bearing back into hub, then lightly tap seal into hub. Put the hub onto the spindle. Put in front bearing, washer, nut, cotterpin, and cap. Replace tire.
how to take off wheel hub on ford 94 F350 dual?