answersLogoWhite

0

Hinges vary in price due to what they are made out of, but you can get a basic hinge for about 4 dollars, but this will vary depending on your location.

User Avatar

Wiki User

17y ago

What else can I help you with?

Continue Learning about Music & Radio

1994 jeep Cherokee how do you remove the door hinge pin i only need to replace the hinge half for the door the A piller half is okay.?

Hello... I have the very same problem. To remove the hinge pin, you must heat the center of the hinge where the pin goes through, and use an air hammer with a flat pointed end. Manage the air hammer under the hinge, point on the bottom of the pin and pull the trigger. Steady the air hammer so it doesn't move around on you. ....Good Luck!!!!


1994 jeep Cherokee how do you remove the door hinge pin i only need to replace the hinge half for the door the A piller half is okay?

Hello... I have the very same problem. To remove the hinge pin, you must heat the center of the hinge where the pin goes through, and use an air hammer with a flat pointed end. Manage the air hammer under the hinge, point on the bottom of the pin and pull the trigger. Steady the air hammer so it doesn't move around on you. ....Good Luck!!!!


What genre is the song things that rhyme with orange?

door-hinge


How do you countersink piano hinge?

I would use a plunge router to mill a groove in both pieces of wood. Clamp the wood and set the depth required using stop's. Slowly run the router milling bit along the wood with a steady progression. Routers are much less expensive than they were.


What is the joint called when it allows movement in one direction?

The joint that allows movement in one direction is called a hinge joint. Hinge joints, such as the elbow and knee, permit flexion and extension along a single axis, similar to the way a door opens and closes. This type of joint restricts movement to a single plane, providing stability and allowing for efficient movement in that direction.

Related Questions

How can I adjust the door by bending the hinge?

Adjusting a door by bending the hinge can be done by loosening the screws on the hinge, gently bending it in the desired direction, and then tightening the screws back in place. Be careful not to bend the hinge too much to avoid damaging it.


How much will it cost for you to send in your ds to fix a broken hinge?

£35


Does the door hinge adjust where the hinge is attached to the hinge post?

door hinges attached to door and hinge post


Why is the shoulderarmand knee called a hinge joint?

The shoulder is not a hinge joint. You probably meant elbow. It is a hinge along with the knee. It is called a hinge because it works much the same as a door that can open and close by having one edge shared with the door jam that holds the door where it is but allows it to move in one plane, back and forth.


What type of joint are the elbow and knee?

Hindge joint


How can I fix a door hinge that is not working properly?

To fix a door hinge that is not working properly, you can try tightening the screws on the hinge, lubricating the hinge with oil or WD-40, or replacing the hinge if it is damaged.


Is hinge a immovable joint?

A hinge joint is not immovable. A hinge joint has one plane of motion. A good illustration of a hinge joint is the knee joint.


How do you replace ford explorer rear window hinge?

To replace the Ford Explorer rear window hinge, you have to buy a similar window hinge. Use a screwdriver to open the hinge and replace the hinge but fitting it in the window.


How can I fix a storm door hinge that is not working properly?

To fix a storm door hinge that is not working properly, you can try tightening the screws on the hinge, lubricating the hinge with oil or silicone spray, or replacing the hinge if it is damaged.


How can I fix a door hinge?

To fix a door hinge, you can tighten the screws on the hinge or replace them if they are stripped. You can also lubricate the hinge with oil or grease to reduce friction. If the hinge is damaged, you may need to replace it with a new one.


What is the plural for hinge?

The plural for hinge is hinges.


The elbow and knee are examples of?

hinge joints that allow movement in one plane, such as bending and straightening.