If all tail lights/stop lights are out could be fuse If only one side is out --probably bad fixture on that side
check brake light switch
The engine computer through the brake light switch.The engine computer through the brake light switch.
tail light bulbs has two filaments inside. One for regular lights and a second for brake lights. One filament is burnt out. Change the bulb.
Something you may not realise is that the brake light bulb is often one bulb with two elements. One of the elements will be for the brake and the other will be for the tail lighting for example so,when tested, the actual bulb will still light up because the second element is unaffected. Make sure that the 'blown' bulb that you are actually changing is not in fact your fog lamp. This will not automatically light up when you test your lights as you have to operate this light separately (similarly to indicator lights). So the fog lamp bulb will appear to be the only one not lit up when you test your lights. Find the bulb with two elements inside and change that one. Sounds obvious (and may be obvious to many) but it's a common mistake. Hope this helps!.
The brake light switch is located near the top of the brake pedal. When the pedal is depressed the switch is activated and sends current to the brake lights. To access the switch, the under dash panel needs to be removed.
How do you remove the brake light cover on a ford focus
The transit brake warning light, on a Ford, can be reset by changing the brake pads. If the warning light is still on after changing the brake pads remove the fuse for 10 seconds.
The transit brake warning light, on a Ford, can be reset by changing the brake pads. If the warning light is still on after changing the brake pads remove the fuse for 10 seconds.
The brake light switch is located under the dash. It is connected to the upper arm on the Brake pedal
The brake light switch can be found below the dashboard on the drivers side of the passenger compartment. The brake light switch simply plugs in and out.
Changing the brake light switch in your Chevrolet Monte Carlo is quite simple. The brake light switch simply plugs in and out.
Changing the brake light relay switch on your 1999 Chevy Cavalier is quite easy. The brake light switch simply plugs in and out.
Brake light switch on the brake pedal is defective
The exclamation light, on your Ford focus, is a reference to the oil needs to be changed. The light can be reset by changing the oil.
Changing a rear brake light on a SEAt Ibiza is simple and will not take a lot of time to do. All you do is unscrew the brake light cover, unscrew the old brake light and then screw back in the new light then screw back on the cover.
AnswerHi,It could mean that they need changing, but on my Escort when the emergency brake lever is pulled up just a notch or two, even though it's not actually engaged, the brake light lights up. Try releasing the brake lever and see if that solves the problem.Hope it helps,CubbyAnswerHi,The emergency brake lever may be engaged by a notch or two causing the light to come on. Try releasing the brake handle and see if that clears it up. If not, then it's probably time to visit your favorite mechanic.Hope this helps,CubbyHello,I also had that same problem in my 2000 ZX3, I disconnected the E-Brake Wires and the light continued to stay on and after a couple weeks of driving around i finally decided to check my brake fluid , and it turns out that the sensor that is connected to the brake fluid container will cause your brake light to come on when your fluid is low, that solved my brake light problem.Hope it helps,Brian
unscrew the light from the spoiler Disconnect the water hose Viola