sw=black
ws-white
rt-red
gr=grey
gn=green
ge=yellow
br=brown
bl=blue
or-orange
vi=violet
stock wire harness speaker wires are always Gray, White< purple< green
For a 1996 Lincoln Town Car, the typical color code for the factory radio wiring is as follows: the constant power wire is usually yellow, the ignition power is red, the ground wire is black, the left speaker wires are light green (positive) and dark green (negative), and the right speaker wires are gray (positive) and purple (negative). However, it's always best to double-check with a wiring diagram specific to your vehicle model to confirm these colors, as there may be variations.
Most likely the speakers are rated for different 'ohms' (or resistance value) in the car stereo wiring. For example, the stock speakers could be rated for 12 ohm wiring, but your aftermarket ones could be rated for 10 ohm wires. The aftermarket speaker would not work, because there is too much resistance in the existing wires. So, either find replace your stock speakers with an OEM (original equipment - manufacturer) part, find an aftermarket speaker that will work with your current wiring, or rerun your speaker wiring (not terrribly difficult, but should still be done by a professional.) Hope this helps.
The speaker wires for the 2007 Jeep Grand Cherokee are dark green and brown for the left front speaker and gray and brown for the right front speaker. The rear speaker wires are dark green and dark blue or violet on the left and gray and tan or gray and dark blue on the right.
For the dual XML 8150 radio, the wiring diagram typically includes color-coded wires for power, ground, speaker outputs, and antenna connections. The main power wire is usually red, the ground is black, and speaker wires vary by color. To get the specific order and connections, refer to the user manual or a detailed wiring schematic for that model, as it will provide the most accurate information. If you don't have access to the manual, consider checking the manufacturer's website or contacting their support for assistance.
Most fords place a wiring diagram on the top cover of their radios.You can use the pin connections to locate the correct wires for each speaker.
The Romex color code for electrical wiring is black for hot wires, white for neutral wires, and bare copper for ground wires.
rad wire to use in neutral and black wier use in phase in home ok this is write answer ok by
The wiring code for speaker wires in a 1989 Jeep Grand Wagoneer typically follows a standard color scheme: the positive wire is usually dark green, and the negative wire is often brown. For the front speakers, the left speaker may have a dark green wire for positive and light green for negative, while the right speaker may use a dark blue wire for positive and light blue for negative. Always refer to a specific wiring diagram for your vehicle to ensure accuracy, as variations can occur.
Assuming there is 8 wires in existing Renault wiring iso speaker plug at back of radio, the two outer wires at each end of plug are for left rear and right rear speakers, tap into these wires i.e. strip the insulation back a couple of inches from the plug and join new speaker wires onto the stripped wires. If only 4 wires in existing Renault wiring iso speaker plug then buy iso speaker plug from auto factor and join existing Renault wiring on speaker plug onto new cable and join new speaker cables (the ones you are fitting) onto the outside wires at each end of the new iso plug.
The red wire is the positive wire. The yellow and green wires are the speaker wires. The brown or black wire is the ground wire. The white wire is and auxiliary wire.
The wiring color code for the Delco radio model 16189885 typically includes the following colors: Yellow for battery positive, Black for ground, and Gray for the illumination. Additional speaker wires may include Purple and Purple/Black for the right front speaker, and Green and Green/Black for the left front speaker. Always refer to the specific wiring diagram for your vehicle, as configurations can vary.
improper wiring, bad or disconnected wires or speaker is broken.
For the 2004 Ford Freestar with a Delphi Delco DVD system, the typical wiring color code is as follows: the power wire is usually red, the ground wire is black, the left speaker wires are typically white (positive) and gray (negative), and the right speaker wires are usually green (positive) and purple (negative). It's important to verify these colors with a wiring diagram specific to your vehicle, as there can be variations. Always exercise caution when working with vehicle electronics.
The standard color code for home wiring is black for hot wires and white for neutral wires.
what colour r my spaker wires in my t reg clio
stock wire harness speaker wires are always Gray, White< purple< green