Any decent car stereo installer will have them, or can order one or can custom wire one for you if needed.
In the Isuzu Rodeos car manual or repair manual there should be a radio diagram. Most radios can be exchanged with the factory radio though a harness may need to be purchased.
Many aftermarket companies sell adapters for aftermarket wire harnesses. They have the original factory harness at one end and you cennect that to the harness that came with the radio. Check your local car audio installer.
call the dealer
if you are using an aftermarket wiring harness hook up the remote turn on wire on the new radio it should be blue with a white stripe to the harness also has a blue and white stripe and plug it in this wire turns on the factory amplifier if you are not using a harness you will have to locate the internal amplifier wire of the radio and connect that to the remote turn on on the aftermarket radio = answer = the inernal apm power wire is white on the black wire harness ANSWER if you dont want to use the factory amp. just run new speaker wires to each speaker.
I imagine a 2002 would have similar wiring to a 2000 Explorer which I've just discovered myself has 2 fuses dedicated to the factory installed trailer wiring. Fuse #3 is for the left trailer signals and fuse #7 is for the right. Hope this helps someone to avoid all the hassle I went through to figure this out.
If it does not have a factory installed harness - U-Haul has a kit with instructions to tap into OEM system
Purchase a service repair manual for the vehicle.
You have to go purchase an aftermarket wiring harness. that will plug into the factory harness then you can wire it to the aftermarket radio.
if factory wal mart sells wire harness and it does some after market serios
Search 'horse harness parts diagram. You will find a few sites.
A factory repair manual should tell you this information. If the factory wires are NOT cut, use a wiring harness adaptor and it is a breeze. Since this post can be edited by anyone, I will not go into how to manually wire a radio. Dr. DB
Go to Metra.com and order a harness . Pry the trim bezel away from the dash with a flat head screw driver. removed the four screws securing the radio and slide it out .Unplug the antenna and harness . The metra harness will plug into the factory harness then follow the wire diagram on your radio and match to the metra harness.
When making changes to a car it is important to have a diagram of the area. The wiring harness diagram to a Pontiac Grand Am can be found in its maintenance manual.
In a motor manual. You can purchase one at most auto parts stores.
Yes with the proper installation kit and harness this can be installed in most vehicles.
The factory wiring harness for the trailers will plug in under the back of the vehicle in the area of the spare tire, the harness plugs into the wiring harness for the tail lights.
In the Isuzu Rodeos car manual or repair manual there should be a radio diagram. Most radios can be exchanged with the factory radio though a harness may need to be purchased.