answersLogoWhite

0

look just behind the downpipe of the exhaust manifold. right at the 2 oclock position of the bellhousing top on a 4.0 when looking at it from front of the car, yes its behind the lip at the hardest place to get to. or access from under the car. i prefer the tip though.

User Avatar

Wiki User

16y ago

What else can I help you with?

Related Questions

Where is crank sensor on 99 jeep 4.0 grand Cherokee?

driver side on the back of the motor where is crak sensor on 94 jeep 4.0 grand Cherokee


Where can you get a governor pressure sensor for a 99 Jeep Grand Cherokee?

Jeep dealer.


Where is crank sensor located on 99 Cherokee xj?

The crank sensor is on the top driver side of the bell housing.


Where is the Dist Module also known as halleffect sensor on a 99 jeep Cherokee?

Crank sensor is on the driver side of the bell housing, Cam sensor is in the distributor. Computer is mounted to the inner fender.


Where is crank sensor 99 jeep 4.7?

You have to remove the starter and the sensor is behind there in the rear of the engine block.


Where is the rear door jamb sensor at on 99 jeep Cherokee?

It is part of the latch inside the door.


98 Jeep Cherokee parts interchangable with 99 Jeep Cherokee parts?

yes, the '98 and '99 are identical


98 Jeep Cherokee?

no, 99


Wiring diagram ignition 99 Jeep Cherokee?

1993 Jeep Cherokee Ignition Wiring ...


97 jeep grand Cherokee 160000 it stalls at exactlt the same point on the road as you are leaving your home about 30 seconds after cranking but picks back up and it is ok until it cools off?

Did you replace the crank shaft sensor? was that the problem? my jeep is doing the same but i only have 85k on a 99'


What would cause a 99 Jeep Cherokee Sport about 135000 miles to cut off after driving for about 5 miles Lights were on but would not start Had it towed and it started for the mechanic the next day?

AnswerIts most likely to be the Crank Position Sensor (CPS) failing.


Does a 99 Jeep Cherokee classic have an interference motor?

No.