0
Add your answer:
Earn +20 pts
How do you install a brake light switch with cruise in a 1990 Jeep Cherokee?
Start by removing the connections for the cruise control and brake lights, then remove the bolt that holds the switch to the brake pedal. Once the brake pedal is loose the switch is held on the brake pushrod by a bushing with nylon retaining washers. Carefully remove one washer and slide the bushing out, the switch can now be removed from the pushrod. Installation is the reverse; line up the hole on the switch with the hole on the pushrod, make sure the tabs for the cruise control and brake lights are facing properly. Reinstall the bushing and replace the other nylon washer, replace the bolt and tighten. Lastly connect the brake lights and cruise control.
When are flashing red and yellow lights used to control some traffic intersections?
Flashing traffic lights are used when the control system is not functioning properly, or when there is very low level traffic (to the point that lights become unnecessary).
2005 Toyota sienna brake lights DO NOT WORKS?
check the fuse that's if the bulb is not burnt out.
Why do your brake lights work but not your tail lights on my 1989 Toyota Camry?
Check bulbs -- they are double filamented--smaller filament for stop lights - larger filament is for tailightsDo parking lights and dash lights work? If not could be a fuse or headlight switchCheck your relay switch located in the trunk, on the driver side, near the rear seat. Might be burned out.
Why would your headlights work on high bim only when you pull the turn signal to you but does not work on low bim or high bim when you turn on the headlights switch in a 1995 jeep Cherokee?
I had the same problem, and it turned out to be a short in the wiring. Mine had the Cruise Control located in the steering wheel and when I turned it off...the lights worked fine.
Why won't my cruise control work in my Toyota pick up even though the cruise control lights work?
the crusie control band is probly broken
Where are the rear fog lights on a 1990 Toyota Celica gtr?
There are not FOG Lights at Rear.
What size are the dashboard lights on a Toyota Celica 2003?
The dashboard lights for a 2003 Celica by Toyota have a maximum overall length of?æ 0.8 inches. The diameter of the bulb is 0.219 inches.
What do the warning lights on a 1988 Toyota Celica mean?
The warning lights on a 1988 Toyota Celica will usually mean that your engine is needing to be serviced. However, the warning lights can also mean that your brakes need to be serviced or repaired.
How can 93 Toyota Celica fog lights be made to come on when headlights are off?
You cant
Where do you find the fuse for the cruise control on a 2000 Ford Focus?
Are you sure you need the fuse for the cruise control. My cruise control wasn't working, neither were my brake lights. All 7 bulbs were burnt out. When the brake lights were replaced the cruise control worked.
Chevy G20 van you changed the rear lights to LED could this cancel the cruise control?
It shouldnt. The cruise control senses by the switch on the pedal not by the lights.
What would cause dash warning lights not come on won't start and battery is good on a 1990 Toyota Celica?
1990 toyota celica when jumper cables are hooked up dash lights turn on but the car won't turn over won't even click
What fuse control the cruise control in a 2000 dodge stratus?
The cruise system shares fuses with the engine and brake lights. If the car runs and the brake lights work, it is not a fuse.
The turn signal and hazard lights no longer work on 2000 Toyota celica what could be the problem?
did you check your fuses
Where can you find rear clear lights for a Toyota celica 1990 gts?
I found mine on eBay for a really good price.
Your 1992 Toyota celica's horn and hazard lights don't work?
check your fuse..90% its the fuse needs relacing.
