If this was my truck, I would look at replacing the headlamp switch if you have checked the fuse and have checked the power going INTO the fuse for that circuit. Good luck.
I had the same problem ,I checked the fuses and couldn't find the blown fuse. There are 2 different fuses. I can't remember the other one so look really close for all the fuses. I think it might have been the same one for the wipers but look real hard and you may find another one blown..
try replacing the dimmer switch they sometimes go bad and do not allow voltage to the lights
Styx was about to go on tour again but Dennis reported an illness involving sensitivity to stage lights and he asked them to postpone the tour. After all that had happened between Dennis and the rest of the band involving directional differences with the Kilroy album/tour, and other past issues, they decided to move on with the tour, replacing him with Lawrence Gowan.
Depends of course on the vehicle but there are different fuses for the locks than the lights. My suggestion is to open the door so the lights are on and pull relays from the fuse block under the hood till they go out. This should disable both auto locks and dome lights.
The constant power line from you radio is shorting out on your radio harness the same thing happened to me the other day
replace fuse
lights are required to be installed on every trailer
did you ever figure out your dash cluster lights. Same thing happened to me. New battery no dash lights? Thanks Russ thecorvetteguy@yahoo.com
hmm as you ask what happened to high beams, i am going to assume that low beam works. id this is correct i would say that your low/high beam switch needs replacing
You can get the best emergency lights installed in the Delaware Vally at ledqusa.
yesterday
Are u talking about replacing the bulb or replacing the light cover?
Tail lights are usually on the same fuse with interior lights and dash lights. That is so you will know when the fuse is blown. Brake lights are usually on a different circuit. If a fuse is blown, try to figure out the cause rather than just replacing the fuse.
replacing dash board lights
Lights are always required to be installed on a boat trailer. This is so no one runs into the back of the trailer, especially at night.
Some lights won't dim. If you've installed the switch properly, and are using traditional incandescent bulbs (not flourescent, LED, E-L lights or any other very low current light), the dimmer will dim the bulbs. Make sure you're using a dimmable bulb and that the dimmer is installed properly.
Yes it had lights. From 1908 until 1909 it had acetylene brass lights. In 1910 electric lights were installed.
Yes