Answer I had a similar problem when I put a CD player in my 92 explorer. The problem was that somehow I used the hot wire from the headlights. I simply just rewired the power wire and problem solved.
First of all I would check the power source. If you didn't use a wiring harness some of the 12v power is discontinued when you turn the headlights on. Using either a voltmeter or testlight check for a constant power source. THE MOST COMMON CAUSE OF THIS IS CONNECTING YOU VEHICLES DASH LIGHT WIRE TO THE GROUND ON THE STEREO
I changed the factory radio in my 98 Nissan Sentra GXE without any problems. I don't even think that model has any antitheft precautions unless they were installed aftermarket. I put in a Sony radio with CD and USB port. If your new radio doesn't work, make sure all the connections are correct and that your new radio isn't at fault. Make sure you plug the antena in... the stereo wont turn on unless the antena and power plugs are in.
maybe the fuses have blown because that happened to my radio and you might have to buy a new radio.
because of the new daylight running lights, and auto headlights this has become quite the issue. However, there is a simple solution. If you set your parking brake before turning on ignition, the headlights should stay off. I have often walked to the car behind me at the drive in and explained that.
Each radio has its own specifc code, if you did not pull the radio and get the code for the serial number on the exsisting radio it is possible that the original radio may have been replaced before and the code you have is for the original radio. You will have to go to a dealer to get the new number with proof of ownership.
new york city
Headlights don't work on 90 tempo L, fuses are all good.Filements are also all good in headlights. New headlight also does not work...
Short answer, no. Not without some work. Your GL1200 radio has an external amp for the speakers. Your standard car radio will not work with the amp. You would have to bypass the amp. Also, the GL1200 radio has a pin connector plug on the back of it. This connector plug has about 30 different pins. You would have to take the end off the bike and directly wire your new radio to the power supply and speakers. The new car radio will not work with the handle bar mounted control swithes. The new radio will not have auto volume. The new radio will not have the intercom system, as that is built into the factory radio. It could be done, but it would take a lot of work. If your current factory radio does not work, I recommend going to eBay and looking for a used replacement. The radio, when working is a pretty good radio, and gets good reception. If your looking for a CD changer, I would avoid it. I have seen satellite radios hooked into the factory radio, but I personally use a FM transmitter for my CD/mp3 player. That way the signal would go through the factory radio on a FM channel and be played over the speakers or through your headsets.
It is the relay that is directly under the radio. same thing happened to me. I popped them out burnished the contacts and put them back in. It worked, if not you'll have to get a new one. Not too expensive.
I would be looking for maybe a grounding issue
most likely a damaged disc reader if its out of warranty it will probably be cheaper to buy a new radio
did you buy a brand new switch? or replace with another old one, i did the same thing on an old Chevy i had 2 switches, 1 would turn my headlights on but no dash, and the other would turn my dashlights on but no headlights, maybe just need to try another used switch. or by a new one.
Then you can see (on the clock) it's time to buy a new radio!
CD players do break but does the radio still work? You may just need to install a new radio
There is 3 fused links above the battery. One controls the headlights. They need to have a new link put on.
Check for a bad ground Im guessing that you connected the new CD player power wire to the illumination wire for the old stereo. Find a power wire that has 12v when the ignition is on.
The new alternator is bad happens all the time.
WHAT ARE YOU DUMB REPALCE YOUR LIGHT BULBS STUPID! Not stupid replaced circuit boards checked fuses ran test light . When headlights are on no brake light or taillights and have all new bulbs stupid. Turn headlights off brake lights work, so figure that out smart man