It is possible that the recall notice was for a specific group of vehicles and may not apply to all Saturn Ions from 2006. It's also possible that the notice was issued by a different entity other than Saturn, such as the National Highway Traffic Safety Administration (NHTSA). You can check the NHTSA website or contact them directly to inquire about any recalls related to gasket issues on your specific vehicle.
The cost of replacing an oil pan gasket for a 2007 Saturn Aura can vary depending on the location and labor rates of the mechanic. On average, you can expect to pay between $200 to $400 for parts and labor. It's recommended to get a few quotes from different mechanics to compare prices.
To repair a leaking cylinder intake valve on a 2003 Saturn, you typically need to remove the cylinder head to access the valves. Depending on the severity of the leak, you may be able to reseat the existing valves or replace just the valve seals. However, if the valves or seats are damaged, replacing them along with the head may be necessary. Always ensure to check for any additional damage and use a new head gasket when reassembling.
To make your own gaskets, you can use gasket material and a gasket punch kit. Trace the shape of the gasket onto the material, then use the punch kit to cut out the gasket. Be sure to use a sharp blade and follow the manufacturer's guidelines for cutting the gasket material.
I don't know which one was at fault but I replaced the head, the head gasket, and the intake manifold gasket.
To drain the transmission on a 1998 Saturn SW2, first, ensure the vehicle is on a level surface and securely raise it using jack stands. Locate the transmission oil pan and place a drain pan underneath, then remove the pan bolts and carefully lower the pan to allow the transmission fluid to drain completely. After draining, clean the mating surfaces, replace the transmission filter if necessary, and reattach the pan with new gasket material or a new gasket, then refill the transmission with the appropriate fluid through the dipstick tube. Always check the fluid level after running the engine to ensure proper operation.
The only repair for a blown head gasket is to replace the gasket.
do a 99 Saturn sl2 have a transmission pan gasket
The head gasket seals between the head and block. The head gasket is inside the engine, up high.
you must remove the timing chain and head. This will then give you access to the head gasket
With tools
probably a head gasket
Blown head gasket or cracked head.
25-35 bucks
a gasket or seal has given up and needs to be replaced
HI!!!! In the CHILTON�s manual of 91-98 saturns, you can find the complete procedure and torque especifications for the change of the head gasket.I think that this book is a good tool to take care of your Saturn.... ATTE: TAVO18. Replacing the head gasket on any vehicle is a long and complicatedprocess, however if you wish to see basic step-by-step instructions goto the related question on the right side of the page"How do you replace a head gasket?"
Replacing an oil pan gasket on a 1998 Saturn SL2 is best done by a trained mechanic. It can be tricky to remove the oil pan gasket in order to install a new one, even though the item itself is readily available at most auto supply retailers.
most likely a blown head gasket, cracked head, or bad intake gasket. with the s series. i would venture to say blown head gasket.