It depends entirely on the device. Give it a try.
Yes, a 110 volt device can be plugged into a 125 volt receptacle. The voltage rating on the receptacle is only there as the highest voltage supply that the manufacturer recommends their equipment be connected to.
When equipment is run at a lower voltage than it is designed for, it does not operate correctly. A light will glow dimly or not at all, a heater produces much less heat. Electronic equipment may not function at all.
When connected to a 110-volt supply, the 60-watt 220-volt lamp will consume power that is calculated using the formula P = V^2 / R, where P is power, V is voltage, and R is resistance. Since the resistance of the lamp remains constant, the power consumption would be (110^2 / 220) = 55 watts. Thus, the lamp would consume 55 watts of power when connected across a 110-volt supply.
To wire a 230 volt contactor with a 110 volt coil, you need to connect the 110 volt power supply to one terminal of the coil and the neutral wire to the other terminal of the coil. Ensure that the contactor is rated for use with a 110 volt control circuit. Additionally, verify the wiring diagram provided with the contactor for proper connection details.
You need a step down voltage transformer that converts 220 volt to 110 volt to use a 110 volt printer with 220 volt. You can get good quality transformers at East West International in Houston, TX. If you order online or over the phone, they can ship it to you in 2-3 business days.
You need a step-up transformer, to go from 110 to 220-240 volts. Then a 110 volt supply can operate 240 volt equipment.
The United States is one of the only places in the world that uses 110 volts instead 220 volts. In order to operate 208 volts on a 110 volt electrical current, you will need a voltage converter.
This device can operate within a voltage range of 110-240V.
When the manufacturer specifies a specific voltage to operate their equipment, that is the voltage that has to be utilized. If you transform the 110 volts from the panel to 220 volts then you are adhering to the manufactures specifications and the device will work. The thing to watch with clocks is the frequency of the clock motor. Clocks are frequency sensitive and if you operate a 50 Hz clock on 60 Hz the clock will not keep accurate time.
no.
Yes, a 110 volt device can be plugged into a 125 volt receptacle. The voltage rating on the receptacle is only there as the highest voltage supply that the manufacturer recommends their equipment be connected to.
No conversion needed. These are nominal voltages which range from 110 to 120 volts. It will operate fine on the outlet.
You have to buy a transformer or converter from 220v to 110v.
no
No, a 240 volt device runs on 240, and a 120 volt device runs on 120. Attempting to run a device on incompatible voltage results in damage.
YELLOW
You need a transformer to do it permanently (the device isn't changed, the voltage is), but you'll often see some type of series resistor added in series with tje power plug for small devices such as electric razors taken to Europe.