TV sets in the USA are designed to run on 120 volts. In other countries TV sets and other appliances are designed to run on the standard voltage in each country.
A US TV set used in Europe would need a 230/120 transformer to run successfuly, but the line standards (data format of the sigals) might also be different.
No, it is not safe to plug a 120v 20 amp welder into a 240v 40 amp outlet. The voltage difference is too high and could damage the welder. It is important to match the voltage and amperage of the welder with the corresponding outlet.
You can, but your circuit will be "protected" by a 30 amp breaker. So you'll have to consider the safety issues of having wiring and appliances that can draw up to 30 amps before tripping the breaker. Will the wiring and circuity support that much current without damage? If not, then switch to a 15 or 20 amp breaker.
At the breaker box the black and white will be on a double-pole breaker (or maybe even two separate breakers). To convert to 110V attach the black to a single pole 15 amp breaker, the white to the neutral bus bar (like all the other whites in there) and the ground to the grounding bar (like the other grounds). Then replace the receptacle with a regular 15amp 110V.
No, a 240V 22A welder requires a 240V outlet for proper operation. Plugging it into a 120V outlet will not provide enough power and could damage the welder or create a safety hazard. It is important to always use the correct voltage and amperage for electrical appliances.
No. The neon sign is fed by a step-up transformer. Primary side 120V, secondary side 7500V. If you applied 240 to the primary side you would get 15000 volts on the neon tube. A flash over and then nothing. If you can find a transformer from 120V to 240V or 240V to 120V then you are good to go. Connect 240V to 240V side and you will get 120V out the other, connect the 120V side to the neon sign and you should have light. Transformer should be at least 100va. This will give you an output of .83 amps at 120V
No.
You will burn up your appliance!!!!!
no because the tv can only pick up siginals at 60Hz if the signal is 50 Hz it won't pic it up.
Don't be stupid. No.
No, it is not safe to plug a 120v 20 amp welder into a 240v 40 amp outlet. The voltage difference is too high and could damage the welder. It is important to match the voltage and amperage of the welder with the corresponding outlet.
You can, but your circuit will be "protected" by a 30 amp breaker. So you'll have to consider the safety issues of having wiring and appliances that can draw up to 30 amps before tripping the breaker. Will the wiring and circuity support that much current without damage? If not, then switch to a 15 or 20 amp breaker.
no.
Don't!
yes. but DO NOT do it the other way.
At the breaker box the black and white will be on a double-pole breaker (or maybe even two separate breakers). To convert to 110V attach the black to a single pole 15 amp breaker, the white to the neutral bus bar (like all the other whites in there) and the ground to the grounding bar (like the other grounds). Then replace the receptacle with a regular 15amp 110V.
Off hand no but your explanations are not clear as to who is doing what to whom,,
First you take out the plug from both the tv and the outlet. Then wait two to thirty minutes and put the outlet in the tv first then in the wall outlet.