A 1986 Leyland DAF 45 typically requires 24 volts to start, as it is a common voltage for commercial vehicles of that era. It is important to ensure your vehicle's electrical system is compatible with the correct voltage to avoid any starting issues.
If your amp meter is showing 208 volts but you need 240 volts, you may need to check the connection or source supplying the power. Ensure that the voltage source can deliver 240 volts and that there are no issues with the wiring or circuit. Consider consulting with a qualified electrician to address the discrepancy and ensure safe operation.
You need the formula: Amps * Volts = Watts But you get to do the math.
A typical big light bulb, like an incandescent bulb, usually requires around 120 volts to operate. However, it's always best to check the specific voltage requirements listed on the bulb itself or its packaging to ensure safe and proper operation.
To convert 7620 volts to 240 volts, you would need to use a transformer. The transformer would step-down the voltage from 7620 volts to 240 volts. The ratio of the turns on the transformer primary and secondary windings determines the voltage transformation.
To calculate volts, you also need to know the resistance (ohms) in the circuit according to Ohm's Law. The formula to find volts is V = I x R, where V is voltage, I is current in amps, and R is resistance in ohms. So, to determine volts given 0.01 amps, you'd need the resistance value.
6 litre turbo diesel I NEED TO KNOW THE MPG OF LEYLAND DAF 8-13 MINE IS A RECOVERY TRUCK
If you need to jump start the car then the battery may be fully charged but it is defective and needs replacing. A full charged battery will read 12.6 volts at the posts with the engine not running. 12 volts indicates the battery is only 25% charged.
a battery should be reading 12 or 13 volts at full charge you would need it over 10 volts but its hypothetical as it depends on the engine size10 To add it's not the voltage that turns the starter motor it is the amount of what is called cranking amps or cold cranking amps cca which refers to the amount of amps when 32 degrees Fahrenheit or up. If you have below the specific amount of amps for your starter it will click, turn but very sold, or do nothing. A 12 volt battery typically needs 400+ amps to start the car. While 5 volts means your battery is dead having 12 volts does not mean your car will start.
You need a step-up transformer.
12 volts
A: WELL you cannot not with 1,2v most LED start emitting at 1.8 v some as high as 5 volts . two need at least two 1.2 volts better is 9 volts then there is a problem voltage wise but the problem is now that you need a limiting resistor to ensure at least 10ma of current
It has to be 13 plus volts to keep the battery charged. The car requires a 12 volt battery to start and run this vehicle, so you need more then 12 volts to keep the battery charged.
2 volts, 5 volts, 12 volts. New computers need even less voltage.
Assuming the car's electrical system is 12 volts, the answer is 12 volts??
18000 volts clearance
No volts need a hard drive. However hard drives need a voltage. Usually about 5 for the data more for the physical movement of the drive.
You don't need anything. A 24v system is the cranking volts. The accessories are done for 12 volts.