1986-1994 models # Loosen but dont remove the upper mount-to-shock tower nuts # Raise and support car # Remove the wheel and tire assembly # Remove the brake flex line-to-strut bolt # Remove the strut-to-knuckle pinch bolts # Using a suitable tool spread knuckle-to-strut pinch joint slightly # Using a suitable prybar place top of bar under fender apron and pry down on knuckle unil strut separates from knuckle be careful not to pinch the brake hose
need diagram of rear brake lines for 1993 mercury topaz
The oil pan on a 1993 Mercury Topaz is typically located underneath the engine towards the rear. You will need to lift the vehicle and access it from underneath to perform any maintenance or to change the oil.
YES Some were all wheel drive. Allthough both front & rear are limited slip, & the rear only if the front wheels are spinning.
Replacing a rear quarter panel on a 1992 Mercury Topaz typically involves welding or bonding the new panel onto the car's structure. Bolting alone is not sufficient as it may not provide the necessary strength and stability for the panel. It is recommended to consult with a professional body shop for this repair to ensure proper installation.
Open the hood, look in the middle space between the firewall and motor. You will see the sensor comming out, IT LOOKS LIKE A SPARK PLUG. YOU WILL ALSO SEE THE CONNECTOR COMMING UP TOWARD YOU. MAKE SURE MOTER IS COOL BEFORE LOOKING.
This is a strut suspension. You have to remove the complete strut. Then you will need a spring compressor to release the coil spring. From there the shock can be changed. It would be cheaper to take the car to someone and have it done as the tool's needed will cost you.
A 1991 mercury topaz has drum brakes on the rear wheels.
need diagram of rear brake lines for 1993 mercury topaz
The oil pan on a 1993 Mercury Topaz is typically located underneath the engine towards the rear. You will need to lift the vehicle and access it from underneath to perform any maintenance or to change the oil.
2001 Mercury Cougar
25 to 35 watts
To change the rear struts on a 2001 Mercury Cougar, first, safely lift and support the vehicle on jack stands. Remove the rear wheels, then unbolt the lower strut mount and detach the upper strut mount inside the trunk. Replace the old struts with new ones, ensuring they are securely fastened, then reassemble the components in reverse order. Finally, reinstall the wheels, lower the car, and perform a test drive to check for proper installation.
A link with more information on this process can be found in related links.
To change the rear strut on a 2002 Hyundai XG350, start by safely lifting the vehicle and securing it on jack stands. Remove the rear wheel, then disconnect the lower strut bolt and the upper strut mount bolts inside the trunk. After detaching the strut assembly, replace it with the new strut, reattach the upper and lower bolts, and finally, reinstall the wheel. Always ensure the suspension is properly aligned after completing the replacement.
YES Some were all wheel drive. Allthough both front & rear are limited slip, & the rear only if the front wheels are spinning.
My 1992 Mercury Topaz right rear line has broken and I see the leak coming out a metal casing. How do I get to line by inside the car because I do not see any lines like in other cars which are located out side the car plase help.
Scrap yard, plenty there.