you take the blue wire and connect it with the red then connect it to the yellow then you cut the green wire and there you go!
The sizing of the generator is dependant on the size of the electric motor driving the mixer.
When current is induced in the rotating coil in an electric generator then a counter couple acts on the current carrying rotating coil in the magnetic field(in accordance to the principle of dc motor). This counter couple is called back motor effect.
Motor Generator
Maybe that motor can turn the generator, but you won't get 2,500 watts out of it. 1 horsepower is only 746 watts. <<>> A one HP motor draws 16 amps on 115 volts and 8 amps on 230 volts. Using the formula W = A x V = 16 x 8 = 1840 watts. It shows that the motor will run on a 2500 watt generator. Where the problem might arise is getting the motor to start. Generally a motor takes 300% of its running current to start. 16 x 300% = 48 starting amps. Back to the first formula W = 48 x 115 = 5520 watts. The 2500 watt generator is just under half of the wattage needed to start the motor. Try the generator, one of three things will happen, one the generator will stall, two the generators breaker will trip or three the motor will run. Some generators have a temporary overload output built into them that will allow the above generator rating output for a certain amount of seconds. If your generator has this feature then the motor will probably start.
Watts = amps x volts. 1000/120 = 8.3. Assuming the oil burner motor is 120V then the generator has the ability to produce 8.3 amps. Find the amperage on the burner pump motor, if it is in this range it will work. The closer the pump amperage is to the generator output the more effect it will have on slowing the generator down on the start. Motors draw up to 300% on start up, this is what makes the generator lag when a motor is connected as a load.
If I'm understanding the question, you are proposing using one motor and one generator, and have the motor spin the generator up to speed, and have the generator attempt to supply power to the motor. The answer is yes, you can do this, but you will be losing energy, not gaining it. The motor and generator's efficiencies are less than 100%, so once you remove the outside source they will slow down until they come to a complete stope, without any other load connected other than themselves.
simply put a motor consumes power and a generator produces it. reactance of a generator = - reactance of a motor
Yes, by giving mechanical power to motor . It acts as a Generator.
Mike Faraday did invent the generator and motor.
a motor is a generator and a generator is a motor, if you are applying a voltage to turn the rotor its a motor and if you are turning the rotor and taking the voltage off the terminals its a generator or alternator.
a motor drives something a generator is driven by something
all the electrical machines can be run either as a motor or as a generator. but dc machines, A motor can be run as generator and vice versa with little modification
You need a 5.5kw generator to run a 5.5kw motor.
Type your answer here... how can you change an ac motor to a dc generator
A motor takes electricity and creates rotating motion. A generator takes rotating motion and turns it into electricity.
when the motor runs more than rated speed it produces leading current and results act as a generator. (or) the motor act as generator when it produces more back e.m.f
Yes you can turn a motor into a generator, if it is a permanent magnet motor.