Pull the left nob and turn it left for the hour change or right for the minutes. there are 2 nobs on the dash... it's the one beneath the clock... that changes luminosity
To reset the mpg, and timer. You need to press and hold both buttons for about 5 to 6 secs.
To set a Vollmond Atomic Wall Clock, first install the batteries and wait for it to receive a signal from the atomic clock. Once the time is set automatically, you can manually adjust it if necessary using the buttons on the clock. Refer to the user manual for specific instructions for your model.
The first time set on a clock is typically 12:00 AM, which represents midnight.
We have H and M buttons right below the clock. Hold on H button to change hours and M button for Minutes. See this video below for more help:
To set atomic clock model 86715, start by locating the time zone switch on the back of the clock and ensuring it is set to the correct time zone. Next, press and hold the "SET" button until the time display starts flashing. Use the "+" and "-" buttons to adjust the hours and minutes to the correct time. Finally, press the "SET" button again to confirm the time setting.
Pull the left nob and turn it left for the hour change or right for the minutes. there are 2 nobs on the dash... it's the one beneath the clock... that changes luminosity
To set the clock on a 1996 Audi A6 Quattro, turn on the ignition and locate the clock display on the dashboard. Press the "Menu" button or the "Set" button depending on your model. Use the "Hour" and "Minute" buttons to adjust the time, then press "Set" again to confirm your changes. Make sure to check the time display to ensure it is set correctly.
To set the clock in a 2009 Audi A4, first, turn on the ignition. Then, press the "Menu" button on the center console to access the MMI (Multi Media Interface). Navigate to the "Settings" option, select "Clock," and adjust the time using the control knob. Once you've set the desired time, confirm your selection to save the changes.
To set the clock on a 1994 Buick Roadmaster, turn the ignition key to the "On" position without starting the engine. Press and hold the "HR" button to set the hour, then press and hold the "MIN" button to set the minutes. Release the buttons once the correct time is displayed, and the clock will keep the new settings.
To set the clock on a 1994 Plymouth Acclaim, first locate the clock adjustment buttons on the dashboard, typically near the radio. Press the "Hour" button to set the hour, and the "Minute" button to set the minutes. Make sure to adjust the time correctly, paying attention to AM and PM. Once set, the clock should keep the time until it needs adjustment again.
The clock tower on the new 100 dollar bill is set at 10:30.
To reset the clock on a 1998 Audi A4, turn on the ignition without starting the engine. Press and hold the "Set" button on the radio or clock display, then use the tuning knob or buttons to adjust the hours and minutes. Release the "Set" button once the correct time is displayed, and the clock will be reset. Make sure to check the owner's manual for specific instructions, as the process may vary slightly by model.
hold set button then hit scan for mins. and seek for hour. then hit set
The clock is set at 4:10 on the back of the $100 bill. The time can be noticed with the help of a 20-fold magnification.
Push the set button and with the set light on, press either the scan or seek buttons to change the hours and minutes. GoodluckJoe
Borrowed from silverado answer: Push the set button and with the set light on, press either the scan or seek buttons to change...
with key in the "acc" position hit the "set" button and then hit the "scan" button for hours and the "seek" button for minutes