To wire a Salzer control switch to an A.O. Smith motor, first determine the wiring configuration of the motor (e.g., single-phase or three-phase). Then, refer to the wiring diagram provided by both the motor manufacturer (A.O. Smith) and the switch manufacturer (Salzer) to identify the appropriate connection points for the power supply, motor leads, and ground. Finally, follow the instructions carefully to ensure a safe and proper connection between the switch and the motor. If in doubt, consult a professional electrician.
For a 3450 RPM, 240 Volt, 23.5 Amp A.O. Smith K56A46B23 compressor motor, a typical run capacitor size would be around 30-35 µF, while a start capacitor might be in the range of 100-150 µF. It's important to ensure that the voltage rating of both capacitors is at least 250 volts to handle the electrical load safely. Always verify the specific requirements in the motor's manual or consult with a professional for precise specifications.
Harry Smith is 78 years old (birthdate: October 10, 1932).
Isaac Newton's stepfather was named Barnabas Smith.
How do you follow Will Smith in the snow? You follow the fresh prints.
Isaac Newton’s stepfather's name was Barnabas Smith.
Yes
Replace it with another.
Check voltage at terminals in motor. 230v- 2 hot legs? Shut off power. Verify shaft turns by rotating by hand. Check continuity to switch contacts and to start capacitor. Short out then test start capacitor. Start switch on motor can have dirty or pitted points. You can file them smooth with a very small file. Verify switch opens completely when centrifugal weight swings by operating it by hand. Are points still stuck together? Do they come back into full contact when switch is let go? Hayward uses AO Smith motors. You didn't mention single or 2 speed, voltage, or symptoms of your problem. I could walk you through any issues with it at all, but alot of it is available on line under 'AO Smith motor troubleshooting'. Good luck.
Brad Smith
Your motor could be siezed. I would purchase a replacement motor. A.O. Smith motor replacements are affordable and then you will be covered by the manufacturer warranty. You can find the lowest prices on A.O. Smith motors (and Emerson motors) with free shipping at www.swimmingpoolsetc.com along with any other parts you may need for your pool.
Yes, he sings the song called switch and many others
Yes, he was. I have two songs by him on my iPod, Switch and Wild Wild West.
Okay, so here is the status update... The stationary switch is an "old style wishbone" type. I don't know why they call it that. I gave the wishbone a little bend towards the outer shaft and I worked. The pump still starts a little excitedly, but the sparks are gone. I believe that if I continue to play with the switch I can get it to work perfectly, but I just don't have the patience for that. FYI-a new switch is around $110~$125. As we all know at that point, I should just buy a new motor. I am kind of discouraged though, seems there isn't an exact science in adjusting these switches, maybe that's why they are so expensive.
Switch is available online for $1.29 from Amazon and iTunes. It is also found on the album "Lost and Found," which can be purchased at music and media stores.
if its rap, no. http://www.youtube.com/watch?v=EXbRJUnqnVM&feature=channel
my brother has a 2001 stratus and had problems with the ingnition switch turning forward. we hired a lock smith to repair it at a fraction of the cost.
Will Smith - Switch http://www.youtube.com/watch?v=4WcmqT2XpdY