It depends on the voltage of the motor, and whether it is single-phase or 3-phase. A 120 VAC 2HP single phase motor draws almost 20 amps, a 240 VAC single-phase 2HP motor draws about 10 amps. A 480 VAC 2HP three-phase motor only draws about 6 amps.
A 1-HP motor is reckoned to draw 7 amps at 240 v single-phase. The same power of motor would draw 3.5 amps at 480 v single-phase, but a 480 v supply could most likely be a three-phase suppy, and the current in that case would be reckoned as 2 amps.
Assuming the power factor is 1, a 10 hp motor operating at 600 volts in a three-phase system would draw approximately 13.33 amps.
The starting current for a 20 HP three-phase motor typically ranges from 4 to 8 times the full-load current. For a 20 HP motor, the full-load current is approximately 24 to 26 amps, depending on the voltage. Therefore, the starting current can be around 96 to 208 amps. Actual values may vary based on the motor's design and specific application conditions.
i have 200 hp motor what i need cable size in 100 feet distance
For a 1.5 hp 230v 3 phase motor, you can calculate the amperage using the formula: Amps = (HP x 746) / (Volts x Efficiency x Power Factor x √3). Assuming an efficiency of 0.85 and a power factor of 0.8, the amperage draw would be approximately 4.3 Amps.
Typically single phase motors go up to 10hp. Wouldn't be very efficient at about 100 amps. A 20hp 3 phase motor at 230v pulls 52 amps. The 10hp single phase 230v pulls 50 amps.
It depends on the voltage of the motor, and whether it is single-phase or 3-phase. A 120 VAC 2HP single phase motor draws almost 20 amps, a 240 VAC single-phase 2HP motor draws about 10 amps. A 480 VAC 2HP three-phase motor only draws about 6 amps.
106 amps
88 amps
The maximum single phase HP motor listed in the CEC is 10 HP. At 115 volts 100 amps and 230 volts 50 amps.
The formula you are looking for is I = W/E. I = 746/220 = 3.39 amps <<>> Rule of thumb Current (Amps) of Single phase 240Vac motors = HP x 5 For Single phase 220Vac use Rule of Thumb and add 0.5A Current (Amps) of three phase 400Vac motors = HP x 1.5 Good for single phase from fractional HP values up to 7.5 HP. Good for three phase HP values up to 30 HP
A single phase 10 HP motor will draw aproximately 50 amps. A three phase 10 HP motor will draw aproximately 28 amps.
The answer is that it depends upon the a. efficiency (to determine its input power). b. supply voltage. c. nature of the supply (single-phase, three-phase, d.c., etc.)
20 HP Three phase 360 volt what is the amps
AO SMITH UST1102 1.0 HP, 3450 RPM, Single Phase, 115/230v
A 1-HP motor is reckoned to draw 7 amps at 240 v single-phase. The same power of motor would draw 3.5 amps at 480 v single-phase, but a 480 v supply could most likely be a three-phase suppy, and the current in that case would be reckoned as 2 amps.