To determine the amperage draw of a 5200 BTU heater, you can use the formula: Amps = BTUs / (Voltage x Efficiency). For example, if the heater operates at 120 volts and has an efficiency of about 100%, it would pull approximately 43.3 amps (5200 BTU / 120 volts). However, many small heaters operate at lower voltages (like 120V), so it's essential to check the specific heater's specifications for accurate amperage.
A typical 120 volt diesel engine block heater can pull around 1000-1500 watts, which would translate to approximately 8-12.5 amps. It's important to check the specifications of the specific block heater you are using to get an accurate measurement.
A 1500 Watt heating element about 1500/110 or 13.64 Amperes from a 110V service. It is assumed the heating element is made from a resistive wire.
On a 50 amp 3 phase connector, you can pull 50 amps per leg. This means that each of the three phases can carry up to 50 amps individually, resulting in a total capacity of 50 amps per leg.
Power(Watts) = I (Amps) x E(Voltage) PIE rule. so 1000 = I x 240. 1000/240 = 4.16667 amps.
To determine the amperage draw of a 5200 BTU heater, you can use the formula: Amps = BTUs / (Voltage x Efficiency). For example, if the heater operates at 120 volts and has an efficiency of about 100%, it would pull approximately 43.3 amps (5200 BTU / 120 volts). However, many small heaters operate at lower voltages (like 120V), so it's essential to check the specific heater's specifications for accurate amperage.
At 120 volts it will pull 4.166 amps. At 240 volts it will pull 2.08 amps.
A typical 120 volt diesel engine block heater can pull around 1000-1500 watts, which would translate to approximately 8-12.5 amps. It's important to check the specifications of the specific block heater you are using to get an accurate measurement.
Aprox 12 amps.
A 120 volt table lamp with a 75 watt bulb will pull 0.625 amps. With a 100 watt bulb it will pull 0.833 amps. And with a modern fluorescent 13 watt bulb it will pull 0.108 amps.
A 1500 Watt heating element about 1500/110 or 13.64 Amperes from a 110V service. It is assumed the heating element is made from a resistive wire.
About 2.25 Amps.
at 230v it will use 5 to 6 amps
10.92 Amp
On a 50 amp 3 phase connector, you can pull 50 amps per leg. This means that each of the three phases can carry up to 50 amps individually, resulting in a total capacity of 50 amps per leg.
This typically has to do with how many amps you can safely pull from the secondary of the transformer.
5