0
What else can I help you with?
The initial reactions in photosynthesis are know as the?
The initial reactions in photosynthesis are known as the light-dependent reactions. These reactions occur in the thylakoid membranes of the chloroplast and involve the absorption of light energy to drive the conversion of water into oxygen, ATP, and NADPH.
When electrons lose energy and return to their initial or ground state what is given off?
Light.
Which part of the eye beside the lens gathers light?
The cornea is the outermost part of the eye that gathers and focuses light onto the lens. It plays a crucial role in the initial bending of light rays as they enter the eye.
The initial activation energy for the process of photosynthesis is?
The initial activation energy for the process of photosynthesis is the energy required to initiate the conversion of light energy into chemical energy. This energy is used to break the bonds in the reactants and start the photosynthetic reactions.
What is the source of magnification in light microscope?
The source of magnification in a light microscope is the combination of the objective lens and the eyepiece lens. The objective lens gathers light from the specimen and forms an initial image, which is further magnified by the eyepiece lens to allow for detailed viewing by the observer.
How long after the detonation of the Light mass Bomb at the end of Gears of War does Gears of War 2 take place?
6 Months
Why would a test light placed on the distributor side of the coil flicker when the engine is cranked?
It is normal. In order for you to create a spark, the coil has to open and close.
When you were changing the oil in your Mazda rx 8 you cranked it with oil cap off now check engine light is ondid i hurt the engine?
As long as it was full of oil when you cranked it, you did no damage whatsoever. The check engine light came on because the ECU detected a problem with the emissions system which was the cap missing. Have the check engine light reset and you will be fine. You can disconnect the negative battery cable for 5 minutes which may or may not reset the light. If not, it will have to be reset with an OBD2 scan tool.
The initial reactions in photosynthesis are know as the?
The initial reactions in photosynthesis are known as the light-dependent reactions. These reactions occur in the thylakoid membranes of the chloroplast and involve the absorption of light energy to drive the conversion of water into oxygen, ATP, and NADPH.
Why doesnt your gears in your dashboard light up?
I do not have gears in my dash board .Try again , also with more info ,like the type of vehicle you are refering .to
Where is the light bulb located for the light showing the different shifting gears P R D it is hard to see at night?
there is no light for it you just have to know your gearshift learn your gears I'm 14 years old and I can drive a manual transmission blindfolded you have to know your vehicle if not get rid of it
Brake light circuit problem?
brake lgiht fuse blows when shifting gears?
Why are helical gears most often used for light-duty passenger vehicles?
Car
What does a shift light tachometer gauge do?
it has a light that comes on to tell you when to change gears in a manual car, really just for show and the light can be adjusted to come on at whatever rpm you desire as long as the car can rev as high as it is set before the revs stall. in reality you change gears by ear and not even by looking at the taco let alone a light.
When electrons lose energy and return to their initial state what is given off?
When electrons lose energy and return to their initial state, they give off light in the form of photons. The energy of the emitted light corresponds to the energy difference between the initial and final states of the electron.
Is the gear shift on a 2004 Hyundai Tucson v6 supposed to light up?
yes.it has to light up in order to show you the gears at night time
What is the best way to achieve a 2 light setup for portrait photography?
To achieve a 2 light setup for portrait photography, position one light as the main light source to illuminate the subject's face, and use the second light as a fill light to reduce shadows and create a balanced lighting effect. Experiment with different angles and distances for each light to achieve the desired look.
