A: By saturating a transistor meaning forward bias the base to emitter the voltage across the collector and base should be very low . depending on current it can be .050 v to .5v reversing or removing the bias voltage this voltage should be the same as the rail
15.
You need the formula: Amps * Volts = Watts But you get to do the math.
To calculate the number of watts when given volts, you also need to know the current (in amps) flowing through the circuit. The formula for power (in watts) is P = V x I, where P is power in watts, V is voltage in volts, and I is current in amps. Without knowing the current, we cannot determine the number of watts from just volts.
To calculate the amperage, use the formula: Amps = Watts / Volts. In this case, it would be 580 watts / 120 volts = 4.83 amps. Therefore, you would need approximately 4.83 amps for a 580 watt device at 120 volts.
To calculate volts, you also need to know the resistance (ohms) in the circuit according to Ohm's Law. The formula to find volts is V = I x R, where V is voltage, I is current in amps, and R is resistance in ohms. So, to determine volts given 0.01 amps, you'd need the resistance value.
If you need to jump start the car then the battery may be fully charged but it is defective and needs replacing. A full charged battery will read 12.6 volts at the posts with the engine not running. 12 volts indicates the battery is only 25% charged.
Assuming the car's electrical system is 12 volts, the answer is 12 volts??
Most batteries today are sealed so a hydrometer is useless. A fully charged battery will read 12.6 volts with a digital volt meter. At 75% charge it will read 12.4 volts, at 50% it will read 12.2 volts and at 25% charge it will read 12 volts. But if you have another type battery then here is what you need to know. A fully charged golf cart battery or fork lift battery will read 1300 A fully charged auto or truck battery will read 1275 A fully charge cell phone tower or solar storage battery will read 1250
Most batteries today are sealed so a hydrometer is useless. A fully charged battery will read 12.6 volts with a digital volt meter. At 75% charge it will read 12.4 volts, at 50% it will read 12.2 volts and at 25% charge it will read 12 volts. But if you have another type battery then here is what you need to know. A fully charged Golf cart battery or fork lift battery will read 1300 A fully charged auto or truck battery will read 1275 A fully charge cell phone tower or solar storage battery will read 1250
Amps, volts and watts are interrelated, but you need to do a little math. Amps * Volts = Watts
10 volts minimum,18 max.
You need to divide the 48 volts by the voltage produced by a single battery.
No volts need a hard drive. However hard drives need a voltage. Usually about 5 for the data more for the physical movement of the drive.
6
How many volts woud it take to charge a laptop
You will need a little more than 9 volts to kill a mosquito. It is recommended that you use about 2850 mAh of current to kill a mosquito.
The answer is 40,000 divided by 415 or 96.38 Amps. Watts is volts times amps.