Watt is a unit of energy transfer rate, in joules per second. Volts is a unit of electric potential, in joules per coulomb. The two units are not related to each other, unless you know more about the circuit, such as resistance or current.
Since current (amperes) is coulombs per second, that would be the simplest conversion, but the question did not provide that information, so it is not answerable other than in the generic terms stated above.
The voltage required to make an arc of 0.5cm can vary depending on factors such as air density and humidity. However, as a general guide, a voltage of around 3,000 to 10,000 volts may be needed to create an arc of 0.5cm in air at atmospheric pressure.
Take the amount of kWh that the meter states that you have used and multiply it by the cost of a kWh in your area.Another AnswerSubtract the energy meter reading from the previous billing period from that from the current billing period to determine the number of kilowatt hours used during that period. Multiply this difference by the cost per kilowatt hour charged by your energy provider. Note, however, some energy providers have a complicated billing system (tariff) in which the cost per kilowatt hour changes according to the amount of energy you use: x cents per kilowatt hour for the first so many kilowatt hours, y cents per kilowatt hour for the next so many kilowatt hours, and so on. Additionally, there may be a multiplication factor based on the changing price of fuel.
It typically takes around 30,000 to 50,000 volts to create an arc of 0.5 cm in air. The exact voltage required can vary based on factors such as humidity and air pressure.
A 1 HP motor running at 120 volts will draw approximately 746 watts. This calculation is based on the formula: Watts = Volts x Amps.
Assuming a standard D battery has a voltage of 1.5 volts, it would take approximately 35 D batteries (52 volts / 1.5 volts per battery = 34.67). However, in reality, you cannot directly power a 52 volt light bulb using D batteries as the voltages do not match.
Volts don't make power. Watts do. Watts = (volts) x (amps) 1 horsepower = 746 watts
Volts don't make power. Watts do. Watts = (volts) x (amps) 1 horsepower = 746 watts (Doesn't matter if the source is AC, DC, or a combination of both.)
4.5~5.3
It is not dependant on voltage. Kettles are made in various voltages. 240v in the UK, 110v in the USA and they even make 12v kettles for vehicles. The amount of work required to boil a kettle is measured in KiloWatt/ Hours. This value will vary depending on the amount of water in the kettle and the efficiency.
6 volts
It will take 36 volts to make 12 amps go through 3 ohms of resistance. Ohm's law states that the current in amperes is equal to voltage over resistance.
12 volts DC.
24 Volts.
You require about 24 volts to power the windshield wiper.
If the 100 amps is powered by 10 volts, you have 1 kw, or 1000 watts. watts = volts X current The 'k' simply means kilo, or thousand.
How many volts woud it take to charge a laptop
it doesn't matter how many volts pass through your body, its the amps as little as 0.1 amps can kill a human