If one terminal of a battery is connected to the frame of the equipment in which it's used, the connection is generally made with the ground, and this is called a ground connection. It refers to the reference point from which all other electrical voltages are measured.
Straight polarity refers to the welding setup in which the electrode is connected to the positive terminal and the workpiece is connected to the negative terminal. Reverse polarity is the opposite setup, with the electrode connected to the negative terminal and the workpiece connected to the positive terminal. These polarity settings affect penetration, heat distribution, and weld quality in different ways.
Star Star TransformerStar Star Transformer is formed in a 3 phase transformer by connecting one terminal of each phase of individual side, together. The common terminal is indicated by suffix 1 in the figure below. If terminal with suffix 1 in both primary and secondary are used as common terminal, voltages of primary and secondary are in same phase. That is why this connection is called zero degree connection or 0o - connection.If the terminals with suffix 1 is connected together in HV side as common point and the terminals with suffix 2 in LV side are connected together as common point, the voltages in primary and secondary will be in opposite phase. Hence, Star Star Transformer connection is called 180o - Connection, of three phase transformer.Vikram Meena
The chassis of electrical equipment is typically connected to the Earth through the Ground (Earth) terminal of the electrical outlet. This is why building wiring should (or must, in many areas) include an on-site Earth ground connection. Earthing of equipment chassis is a safety measure taken to help prevent electrical shock in the event of an insulation failure or a short circuit. If there were no chassis-ground connection, a hot wire which accidentally comes in contact with the chassis could cause the user to get a serious shock. If there's no Earth connection available, use a GFCI outlet to help prevent electrocution.
The black terminal is typically connected to the negative terminal on the circuit, while one of the red terminals is connected to the positive terminal. The other red terminal is used to measure the voltage across the circuit by placing it in parallel with the component or point where you want to measure the voltage.
They move from the positive to the negative. There are more specific answers to this question so I recommend that you read several of the answers that are offered.
If this connection is used, it is generally connected to the light in the dash that shows alternator fault (NOT the voltage gauge!) and then through the ignition switch to the positive battery terminal.
Yes, Terminal A and Terminal B are connected at Orlando International Airport (MCO).
A computer that is connected to a server is known as either a client or a terminal depending on what the end computer is capable of accomplishing without connection to the server.
an object connected?? if so, it can be called a node/ a DTE (Data Terminal Equipment)
Each component in a network connected by wires is called a terminal. Components in a network that are not connected by wires, such as in a shared Wi-Fi connection are also called terminals.
ncomputing using terminal service like we use for vnc (virtual network connection), like windows have remote desktop, on Linux generally using vnc for default remote connection. by ncomputech.com
The positive terminal of the battery would be connected to the positive terminal of the ammeter. The load would then be connected between the two negative terminals, positive side of the load being connected to the negative side of the ammeter.
Router, computer comes under Data terminal equipment and modem, network terminal comes under data communication equipment.
Center terminal is connected to the positive from the battery. Outside is connected to ground (-).
The hot wire is typically connected to the line terminal.
The blue wire on a Honeywell thermostat should be connected to the "C" terminal for proper functioning.
The electrode connected to the negative terminal of a cell is called the cathode.