The unit is amper (A) (or submultiples).
There is no direct conversion between cranking amps and volts. Cranking amps (CA) measure the amount of current a battery can provide for a short period, while volts measure the electrical potential difference. A battery's voltage is typically around 12 volts for a standard automotive battery.
A battery contains a charge of electrons. When these electrons leave the battery and travel through a circuit that is described as current.
Amp hours is a battery rating. It means that this battery can sustain 1 amp for 8 hours up to 8 amps for 1 hour. Depending on what the current draw is on the load will determine the length of time the battery will last.
A storage battery produces direct current (DC). This type of current flows in a constant direction from the positive terminal to the negative terminal of the battery.
No. 500 mAh typicallywould refer to the capacity of a battery that can provide 500 milliamps (1/2 amp) to a load for a period of 1 hr. 5 A is 5 amps which is equivalent to 5000 mA. It is just a rating of current flow at a point in a circuit at an instant of time.
To measure voltage be in parallel with the battery. Series would measure current. Parallel measures potential.
amps 'an electrical measure of current.'An ammeter is an instrument used to measure current (amperes), you dont measure ammeters!YEAH
Measures the amperage of the current .Your battery is in series with your car amp meter .
A battery stores charge and supplies voltage and current. A kilowatt (KW) is a measure of power = Volts x Amps.
this problem can be fixed by refferring to mannual of that battery and also can calculated by another way use a load 10 watt on your battery and measure the current flowing through it and note the current time after that when your battery discharge multiply the measured current from hour(during discharge period). this result is your amp-h rating of battery.
The battery is used by the meter to apply a voltage across the resistance being measured and determine the current which determines the resistance. If there is no battery it can't supply the voltage and can't measure current, so no reading.
2 amperes (current = voltage/resistance)
You are confusing terms. Current is measured in amps or some fraction thereof. If you have a 24 volt battery (All batteries are DC) you need to connect a load to the battery and then measure the current that flows in the circuit. The current is measured in amps, milliamps or perhaps microamps for a very high resistance load.
12 V - probably, although ther are exceptions. 6 Amps - ?? 6 Ams would be a measure of a current draw, and a battery is a current source. A car battery might have a capacity of 60 amp hours or thereabouts.
we can increase the current in battery by using current amplifiers or chopper's s the easy way to increase the current in battery........
To calculate the mAh capacity, we need to know the current rating of the battery as well. The mAh (milliampere-hour) capacity is a measure of how much charge a battery can hold over time. It is not determined solely by the voltage (9.6V in this case) but also by the current rating of the battery.
It's all relative. A battery has internal resistance. Batteries are not "ideal" voltage sources. If there is a "heavy" load on the battery (low resistance), the voltage you measure on the outside of the battery will be lower. A car battery is normally thought of as a 12 volt battery. When there is no load (disconnected) you can often measure in excess of 13 volts if it's fully charged. During normal cranking of the engine, the voltage can drop below 11 volts.