answersLogoWhite

0

There are a number of hinge joints (not points): at each elbow, at each knee, interphalangeal joints (between the fingers) and at each ankle.

User Avatar

Wiki User

12y ago

What else can I help you with?

Related Questions

What is a double hinge?

A double hinge is a type of hinge that features two pivot points, allowing for increased flexibility and range of motion for the attached components. It is commonly used in folding mechanisms and applications where a wider range of movement is necessary.


What are 4 examples of your elbow?

hinge joint


How much is hinge?

Hinges vary in price due to what they are made out of, but you can get a basic hinge for about 4 dollars, but this will vary depending on your location.


How do I know what size hinge I have?

To determine the size of a hinge, measure the length and width of the hinge plate. The standard size categories are 2", 2.5", 3", 3.5", and 4". You can also check the packaging or product specifications for the hinge size information.


What is the difference between a 1/2 vs 1 1/4 overlay hinge?

A 1/2 overlay hinge covers half of the cabinet frame, while a 1 1/4 overlay hinge covers more than half, extending further onto the frame.


What are the different door hinge sizes available for installation?

The most common door hinge sizes available for installation are 3.5 inches, 4 inches, and 4.5 inches. These sizes refer to the length of the hinge when fully extended.


What do the scapulae and clavicles form?

These two form a hinge for your upper arm.Those are the scientific names for the shoulder and collar bones respectively


How can you lessen friction in the hinge of your cabinet?

To lessen friction in the hinge of your cabinet, you can apply a small amount of lubricant like WD-40 or silicone spray to the hinge pivot points. Make sure to wipe off any excess lubricant to prevent buildup of dirt and debris that can increase friction over time. If the hinge is still not functioning smoothly, check for any obstructions or misalignments that may be causing the friction.


What is the hole spacing on a European hinge plate?

The standard hole spacing on a European hinge plate is typically 32mm (1-1/4 inches). This spacing allows for flexibility in adjusting the position of the hinge on the cabinet door for proper alignment and operation.


Repairing door hinges 1990 Lincoln Town Car?

NOTE: Front and rear door hinge checks can be removed and installed using the same procedure. NOTE: The front door hinge check can be serviced without removing the complete hinge assembly. Perform the following procedure: Removal 1. Open door with broken hinge check. 2. Remove exposed hinge-to-body retaining bolt and retain. 3. Insert a chisel, 267mm (10-1/2 inches) long with a 19mm (3/4 inch) cutting blade, between hinge half on body and back side of hinge check. Hammer until chisel unseats rivet securing hinge check-to-body side hinge. 4. Remove broken hinge check and discard. Installation 1. Loosely place new door check and elastomer reinforcement into body door hinge. 2. Install door hinge-to-body retaining bolt to secure new hinge check and reinforcement-to-body side hinge. Tighten bolt to 25-35 N-m (19-25 lb-ft).


Does the door hinge adjust where the hinge is attached to the hinge post?

door hinges attached to door and hinge post


4 b P of a C?

4 Basic (Cardinal) Points of a Compass