answersLogoWhite

0

Check the manual on that one. You may need to use a jumper to allow the timing to be changed. Check to see if there is a wire right below or connected to the distributor that has a cap on it. Open it up and you might see a 2 connector plug. That might be the place to put the jumper, but don't just go ahead and do it until you read the service manual on that one and figure out where the right procedure and the right setting. does the tachometer jump around before it shuts off? if so i fixed this by replacing the distributor.

User Avatar

Wiki User

18y ago

What else can I help you with?

Related Questions

Why does engine run if the distributor is turned to fire at 45 degree before top dead center but dies if rotated back towards original marked position?

Distributor is installed off a tooth, or wires are on the wrong spots.


Do you have to removed the distributor off engine to change pick up coil?

Usually, NO.


Which direction must a camshaft be rotated on a diesel engine with a crankshaft that is rotated clockwise?

counterclockwise


How do you change the distributor on a Ford truck?

Rotate engine to TDC Intake Stroke Remove Distributor cap Remove vacuum line to vacuum advance if equipped Remove horsehoe type clamp on side of distributor Lift out distributor


Where is the cam sensor on a 1995 Mazda Protege?

It takes about .9 of an hour to change regardless of which engine you have.(book time) it is located on the distributor, you have to remove the distributor to check it and/or replace it.


Where is the distributor on a 1993 Corvette?

The distributor is on the front of the engine.


Where is the distributor cap on a 1991 520?

The 1991 BMW 520 distributor Can be found on the back side of the engine. The distributor Will be on the top of the engine.


Can the timing gear that you see when you remove the distributor on a 1969 350 Chevy engine be pulled out while removing the distributor and change the position of the gear that drived the distributor?

no the gear stays in place , unless you take the timing gear cover off + the bolts that hold it to the cam shaft.no it won't change the position either unless you crank the engine, the gear stays in place.


Can you use the distributor from a 7mgte Toyota supra engine on a 7mge engine?

7mgte doesnt have a distributor. it has coil packs. only 7mge has distributor


Where is the oil sensor for a Dodge 318 engine?

It is on the rear of the engine, next to the distributor.It is on the rear of the engine, next to the distributor.


How do you change the distributor on a 1996 Nissan 240SX?

buy a new distributor cap and rotor. Unscrew the distributor cap (on the drivers side of the engine block), take note how the existing rotor is sitting, remove it, and place the new rotor in the same position. Put on the distributor cap and screw it into place... very simple job. thats how you change the rotor......he asked about the distributor....try again.


Are all ford engines have distributor in front of engine?

The V8 engines and the 3.8 liter V6 engine have the distributor in front The other size V6 engines have the distributor at the rear The straight 6 cylinder engine has the distributor on the drivers side