If it is stuck there it means that your float in the gas tank is stuck or you have lost power between the sending unit and the fuel gauge. If you are not an experienced mechanic don't try adding power to it because you can and probably will cause the gas tank to blow up.
[He] 2s2 2p2 (the 2's to the right of each letter mean squared)
A tirrill burner has a barrel, air vents, gas inlet and needle valve. The barrel turns on a threaded mount to allow air; the air vents limit the air entry into the barrel; the gas inlet is where the gas flows; and the needle valve regulates the gas flow.
usually a change in temperature.... OR PRESSURE Which all mean a change in entropy of the system
Pretty much all of them, under the right conditions.
A gas that is not man-made or refined.
when the needle is all the way to the right(away from the red) the tank is full the closer the needle gets to the red the less gas you have
how do u fix a gas needle on a 2004 nissan maxima
Adjusting the gas needle valve controls the flow rate of gas entering the burner. Decreasing the gas flow by turning the needle valve counterclockwise results in a smaller, bluer flame with less heat, while increasing the gas flow by turning the needle valve clockwise produces a larger, yellower flame with more heat.
no
Probably a 4 Barrel carburetor< i used to have a pick up truck and you could see the gas gauge move when all 4 barrels kicked in
If you mean gas in the digestive tract, then yes it can.
The needle valve controls the flow of gas into the Bunsen burner, regulating the size and intensity of the flame. By adjusting the needle valve, you can increase or decrease the amount of gas entering the burner, which in turn alters the flame's temperature and size.
No, they stick a needle in there a**, which kills them painlessly.
If you are getting gas and rapidly getting rid of it (or burning it) or if your car is broken.
The needle valve or flow valve controls the flow of gas into the Bunsen Burner.
if the float/needle assembly do not seat properly. the gas will slowly leak past the needle and into the cylinder-then past the rings into the oil. you probably need a carburetor rebuild.
Type your answer here... change sending unit located in the gas tank