Hey Donali==The u/s stands for up shift. This tells you when to upshift the trans for the best economy. If it has been a while since it has been tuned up it probably needs one. GoodluckJoe
Chloroplast converts light energy into chemical energy.Solar panel converts light energy into electric energy.
A solar panel converts light to energy, which is similar to a chloroplast converting light to carbohydrates for energy.
normally sensor is on drive shaft , but in some Renault models speed sensor is taken from ABS unit- if ABS itself is fine it could be due to fault in wiring. on some models you check speedo cluster (instrument panel) by pressing knob on instrument panel for about 5 seconds and all the dials start moving. if it works then it means wiring problem. only Renault can solve this problem ( french technology)
Shift light, maybe? If it comes on around at a certain RPM every time, that'd be my guess.
Electrons move in a solar panel because of something called the photoelectric effect. Light, such as from the sun is made up of photons. When a photon strikes a metal, it knocks lose electrons. This effect can vary based on the type of metal. Solar panels are designed to allow electrons to be easily effected.
its on the drivers side kick panel
hammer and sledge
It's located on the inside of the fuse door panel.
The diagnostic port on a 1995 Isuzu Rodeo drive is located on the lower kick panel on the driver's side. It is just below the left spark plug.
You have to remove the entire light assy. There are some screws that are hard to find but they are there. accessed from the outside 3 in all use a medium length Phillips screwdriver. GoodluckJoe
To change a dashboard light for a 1996 Isuzu Rodeo, first disconnect the negative battery terminal for safety. Remove the dashboard panel by unscrewing any necessary screws and gently prying it off. Locate the faulty bulb in the instrument cluster, twist it counterclockwise to remove it, and replace it with a new bulb. Finally, reassemble the dashboard and reconnect the battery.
To change the dashboard light on a 2002 Isuzu Rodeo, first, disconnect the negative battery terminal to ensure safety. Remove the dashboard panel by unscrewing any screws and gently prying it off. Locate the burnt-out bulb behind the dashboard, twist it counterclockwise to remove it, and replace it with a new bulb. Finally, reassemble the dashboard and reconnect the battery.
To remove the rear door panel of a 1999 Isuzu Rodeo, first, ensure the window is fully closed. Start by removing any screws that are securing the panel, usually found near the door handle and armrest. Next, gently pry off the panel using a trim removal tool, being cautious to avoid breaking any clips. Once loose, disconnect any wiring harnesses for power windows or locks before fully removing the panel.
The engine is running hot for some reason. Check thermostat, radiator and coolant level.
seems to be in the same place for 2x2 or 4x4, drivers side under dash mounted above kick panel
in the 1996 it is rear cargo area on the driver side, there is a small hatch in the molded plastic on the sidewall that has a "dial" you turn to bring the panel out, it will be in there. it is a small scissor jack
Open the drivers door and it's right there on the side of the dash. There's and box in the engine compartment also for most of the engine relays and fuses.