They are extremely efficient in their use of energy for producing light. Better even than compact fluorescents, and they do not liberate Mercury into the einvironment over their lifetime as CFs do. There are some adverse effects in their manufacture, and eventual disposal... as with any "product".
It depend on what the rating voltage of the LEDs are.
The available color of LEDs are infrared, red, yellow, green, white, orange, blue, violet, ultraviolet and purple.
To find the total voltage needed for the LEDs, first calculate the total power by multiplying the number of LEDs by their power consumption: 12 LEDs * 3W = 36W. Then, divide the total power by the total current to find the voltage: 36W / 0.7A = 51.43V. Therefore, you would need approximately 51.43 volts for the 12 LEDs.
tempeture,ph, solute concentration and salt content
There is no such thing as a white LED. You produce white light from LEDs by combining red, green and blue LEDs. Red LEDs were produced first because red is a low frequency of light. It was the easiest to make. Green LEDs were produced next because green is a higher frequency of light. It was harder to make. By combining red and green LEDs, you can produce yellow light. Blue is a very high frequency of light and is very hard to produce. Blue LEDs and blue lasers (as in BluRay) took a great deal of effort to create. LED technology and some kinds of laser technology are very closely related.
If your compairing apples to apples like 3 watt leds to 3w leds then 128. The more leds the higher the power.
Yes, LEDs are dimmable.
Basically, when LEDs are connected in parallel, the LEDs with the lowest resistance will be the brightest, the other LEDs will be dimly lit or not lit at all. Therefore, use LEDs with the same model number and colour.
Penis
No.
red, green, yellow, blue leds
Most modern torches have LEDs in them, several newer models of Audis do too.
It depend on what the rating voltage of the LEDs are.
SemiLEDS Corporation (LEDS) had its IPO in 2010.
Resistors don't light up LEDs. They're required in a circuit along with LEDs in order to prevent excessive current through the LEDs when the LEDs are forward biased. The correct resistance value depends on the supply voltage and the desired (rated) current through the LEDs, and there's typically one resistor in series with each LED.
weather
higher prices for consumers