when the magnitude of voltage of a source is controlled by another small voltage source in the circuit the former is called voltage controlled voltage source and the later is called controller voltage source.
Line voltage is understood as the voltage that the device or appliance needs to operate on. It is also referred to as the devices working voltage. Once the proper line voltage or working voltage is applied to the device it may be transformed to different voltages for different internal component circuits.
Another name for average voltage is the RMS (Root Mean Square). This is a voltage derived from the peak to peak voltage multiplied by .707. If the peak to peak voltage is 170 volts then the average voltage (RMS) would be 170 x .707 = 120 volts.
Line to line voltage is not the same as line to neutral voltage because line voltages are 120 degrees apart. They are related by: Line to neutral voltage * tan (120 degrees) = Line to neutral voltage * 1.73.Additional CommentFor delta-connected systems, the line voltage is the same as the phase voltage.For wye-connected systems, the line voltage is larger than the phase voltage by a factor of 1.732. The reason for this is as follows:Because any two phase voltages are displaced from each other by 120o, they must be added vectorially, not algebraically, to find the line voltage. As the above answer points out, this means that the relationship between the two is the square-root of 3, or 1.732.
There is only 1 type of DC voltage, and that is direct current. In order to better answer your question, you need to be more specific.
110-120 Volts BUT IN SOME AREAS 220.
It is 120V/60Hz
110-120 volts
Yes. The USA has the same voltage of Mexico but in some areas it is 220 volts! So you will need to buy a converter.:)
Mexico uses the 120V/60Hz standard. You should be aware that when plugging older appliances, they most surely would require a a voltage regulator.
Voltage is the potential difference between the source & any point in the circuit. The forward voltage is the voltage drop across the diode if the voltage at the anode is more positive than the voltage at the cathode (if you connect + to the anode). Voltage drop means, amount of voltage by which voltage across load resistor is less then the source voltage.
Voltage gain is the ratio of the output voltage of an amplifier to its input voltage.
bucking voltage is a voltage which is of opposite polarity to the voltage it acts .
Voltage Stabilizer is also called Automatic Voltage Stabilizer or AC Voltage Stabilizer or Voltage Regulator. Actually an automatic voltage stabilizer is designed to automatically maintain a constant voltage level, with protections of equipment against voltage surges, over voltage, under voltage, smoothing impulsive noise.
the difference between a voltage converter to a voltage regulator,is that a voltage converter,converts or changing the desired voltage to be used while the voltage regulator,regulates the input of the voltage amount not to excess to its inputs.
There is no formula to convert voltage. Voltage is universal.
the device oprates on the minimum voltage. in this voltage is called threshold voltage.