I believe this would vary with
A. The diameter of the inside of the hose, and
B. The pressure of water going through the hose.
You could always try filling up a litre container with a stopwatch and divide that number of seconds by 60.
The time it takes to fill a volume with water using a standard hose depends on the flow rate of the hose. Without knowing this flow rate, it is not possible to provide an accurate estimate of the time needed to fill 896 cubic feet.
No, water with a greater volume will cool slower than water with a lower volume because it takes more energy to heat or cool a larger volume of water. The larger volume of water will retain heat longer than the smaller volume.
Condensed water from an air conditioner is collected in a drip pan or tray located underneath the unit. This water is then drained through a pipe or hose to a designated area, such as a drain or outside through a condensate pump.
Air pressure helps by pushing water through the hose or sprinkler system, allowing for a consistent flow of water to reach the lawn. The pressure also helps to create a strong spray from the sprinkler, ensuring that water is distributed evenly across the lawn.
To calculate the volume of water displaced by an anchor on the ocean floor, you can use Archimedes' principle. The volume of water displaced will be equal to the volume of the anchor that is submerged underwater. By knowing the density of water and the weight of the anchor, you can calculate the volume of water displaced.
water pressure goes down because the force of the water going through the space decreases
1.03 gallons
Volume of a cylinder = (pi) x (radius)2 x (length) Volume of the hose = (pi) x (2 in)2 x (1200 in) = 15,080 cubic inches= 65.28 gallons That's the volume of the hose. We have no way to tell how much water there may be in it.
There need not be any water in the hose! Its capacity is approx 163461 cm3 or 163.5 litres.
The capacity of a 25 ft hose with a diameter of 3 inches is 1.23 cubic feet. That is the maximum volume of water in the hose: there need not be any!
If you are asking about a garden water hose. This can move with the force of water traveling through it. It can also move from the temperature of the water it holds.
When the thermostat is closed, the coolant circulates through the bypass hose from the water pump to the block.When the thermostat is closed, the coolant circulates through the bypass hose from the water pump to the block.
To accurately measure the water usage of your garden hose with a water meter, you can attach the water meter to the hose bib where the hose is connected. The meter will track the amount of water flowing through the hose, allowing you to monitor and record the usage accurately.
A pitcher pump with a hose attachment works by using a handle to create suction that pulls water up from a well through a pipe. The water is then pushed through the hose for use.
I assume you want to find out how much water fits in the hose. Treat the hose as a cylinder - that should be a good approximation, even when you bend it. Measure the length and the interior diameter. Divide the diameter by 2 to get the radius. Convert everything to feet, and finally use the formula for a cylinder to get the volume.
You have a top radiator hose and a bottom radiator hose.
A standard fire hose is 50 feet long. A hose this length with a 2-inch radius grants about 4.36 cubic feet. This volume holds 32 gallons of water.