Putting a water hose in the motor is not recommended as it can cause damage to the engine. Water entering the motor can lead to hydro-lock, which can result in severe engine damage. It is essential to keep water away from the motor and use appropriate cleaning methods.
it melts
Water will no longer be put back into the the air by transpiration
it will swell, but won't lyse.
because the water in the beaker would evaoprate into it then condense on the surface of the syringe
You can't read amps directly from outlet. You need to either put an amp meter in series with the current between the outlet and the load or use a clamp on ammeter on a single wire, not the pair of wires in an extension cord. Think about electricity being a vat full of water and the outlet as a spigot. To power a lamp think about connecting this spigot by a hose to a lamp. Also think about a return hose from the lamp to get rid of water. Until you turn on the spigot, no water flows so you can't measure it. If you try to measure in bot directions at once the flows cancel each other out and you get zero. To get a measure of flow you just measure flow in one hose or the other.
coil the hose and put it in a bucket of warm water..or if no warm water put in some water..
you must first put on your yamaha hose adapter for your garden hose. then without turning the water on plug the hose into the yamaha. there should be a place to put the hose in the engine compartment. then start your engine the turn the water on. make sure the water never on when the engine is off. let the pwc run at idle speed for 240 seconds (4 mins). then turn the water off and shut down your engine. gracias
Hose and you tell a Girl to put her mouth on the end of the hose and when her mouth is on the hose you sticky tape around it and then when you are finished take a photo of the girl with a hose in her mouth and then you turn on the hose and all the water will pour into her body and she will be a Water Balloon.
You would have to put a casing around it, find a different incoming water hose, and adapt the drain hose.
Connect a hose to your faucet and turn it on, put the hose in the water.
A fire hose reel typically contains water to put out fires. The water is expelled under pressure when the hose is activated to help extinguish flames.
i have a 02 and replaced blower motor myself 22.00 dollars 4 new motor at auto zone pasenger side under the hood on the fire wall 4 little screws and one conector also a little hose pull hose out pull motor out a cricle clip pin holding fan on 2 motor pull off remove fan replace on to new motor put hose on new motor slips on easy put motor back into place screw 4 screws back on put hose on conect conector you are now finshed and replaced your blower motor for under 25.00 dollars good luck
antifreeze keeps your car from overheating, it flows thru your radiator hose, without it your motor would blow
top radiator hose, Engine side, metal nippile that attaches hose to motor,,,,,,,,,,,,,, Its under the nipple Top radiator hose,, engine side,,metal nipple that attaches hose to motor,, its under the nipple,,,,,,,,,,,,,,,,, be sure to put the new t-stat in with the larger brass side toward the motor.
your skimmer basket is full and it is not takink in any water. put water in your pool with a garden hose.
Flush all coolant from system by loosening lower rad hose (when cool) and catching all fluid with a bucket. Use a garden hose to flush radiator from upper cap. When drained and flushed fill with 50/50 coolant/water.
follow the radiator hose that goes to the motor, the thermostat housing is the thing the hose is hooked to and it is bolted to the motor with three bolt i believe. you take the hose off, the housing off and just take the old thermostat out and put the new one in.