answersLogoWhite

0

don't know suck it up!!

User Avatar

Wiki User

13y ago

What else can I help you with?

Related Questions

How do you hook up switch leg?

diagram to hook up switch leg


Why does your tilt trim on your boat go up and down when im not moving but drops when you move and wont come up when im moving?

The tilting trim on your boat may be experiencing a hydraulic issue or a malfunctioning trim switch. When the boat is stationary, the hydraulic fluid can settle, allowing the trim to move up and down due to gravity or pressure changes. However, when you're moving, the pressure created by the water may prevent the trim from rising, possibly due to a blockage or leak in the system. It's best to check the hydraulic fluid level, inspect for leaks, and ensure the trim motor and switch are functioning properly.


Where is the power trim on mercury 115 outboard?

On the right side of the engine (looking from behind) there is a switch with two press-on sides (up, down) or at the throttle control (obviously inside the boat )


Can you hook the Nintendo Switch up to your TV?

Yes. The Nintendo Switch can be played on your TV.


What is the wiring schematic for a 1989 Ford F-250 to hook up to boat trailer?

wiring to hook up a boat trailer is the same as any other trailer. most plugs obtained from an auto store will have diagram and instructios


Why would the cooling fans on a 91 Honda prelude si not come on?

id have to look to see why but what you can do is get new fans and hook it up to a toggle switch. when you hook the toggle switch up just flip the switch before it gets too hot


Should I buy a Nintendo Switch Lite or Nintendo Switch?

just nintendo switch to can hook it up to the tv and play with friends


How do you wire a rocker switch to radiator fan on a Grand Am?

to shut the fans on and off by yourself. remove the connector for the wires at the fan. hook a wire from the positive on fan motor to the inside toggle switch, do not hook to switch yet. run a wire from the positive on battery, hook to battery after hooking up switch. hook up the wires to the switch. then the battery. its up to you if you want to install a 15 amp fuse in line from battery to toggle switch.. you can also get the power from the fuse box instead of the battery. this should work for you. if not you may need to ground the other fan wire.


If you are trying to hook up a tach to your '90 Bonneville which wire should you hook it up to to get an rpm reading?

to hook up the tach use the hot lead on the disributor and to any good ground wire and if there is a light hook it to the wire on you light switch


How do i wire a toggle switch for an amp?

Hook a switch up to the remote turn on and ground. Before the wiring for the amp.


How do you replace the mirror switch-knob on a 2000 VW Jetta?

The easiest way to change the switch is to slide a small screwdriver between the old switch and the trim on the door towards the front of the car. It has to go in a bit more than a centimeter to release the catch on the switch. You can see how far by looking at the new switch. The small screw driver will stay in place by itself since it is squeezed between the switch and the trim. Place a coin or something hard on the trim close to the switch, and take another screwdriver and slip it under the switch and pry outwards against the coin. The switch should pop out and you can grab it and pull out far enough to disengage the cable. Then just hook up the new one and pop it back into place.


How do you hook up a 3-way switch in a circuit?

To hook up a 3-way switch in a circuit, you need to connect the common terminal of one switch to the power source, the common terminal of the other switch to the light fixture, and the travelers of both switches together. This allows you to control the light from two different locations.