The settings for an ortho drop spreader typically depend on the type of material being applied, such as fertilizer, seed, or herbicide. Generally, you can adjust the flow rate by turning the dial or lever on the spreader to the recommended setting indicated on the product label. It's important to calibrate the spreader according to the manufacturer's guidelines for even distribution and to avoid over-application. Always check the specific instructions for the material you're using for the best results.
What is the Ortho Spreader 5000 for overseeding
The correct setting for both spreaders is 3
#4 setting
Spreader settings for Scotts manufactured spreaders are listed on the back of the bag.
The spreader setting for Scotts Southern Turf Builder when using the EZ Broadcast spreader by Republic is 3.5. If you are using the EZ Drop Spreader by Republic the spreader setting is 6.5.
No
For the Scott's Speedy Green 2000 spreader, the recommended setting for applying Ortho Bug B Gone is typically around 3 to 4. However, it's always best to check the product label for specific instructions, as application rates may vary based on the formulation. Additionally, calibrating your spreader based on your lawn size and the product's coverage guidelines can ensure effective application.
The Scott drop spreader PF3 is designed for residential lawn care, ideal for applying fertilizers, seeds, and other granular products. Its setting typically involves adjusting the spreader to the appropriate setting based on the type of material being used and the desired application rate. The spreader is suitable for various lawn sizes and is built for ease of use on flat terrains. Always refer to the specific product guidelines for optimal settings.
For a drop spreader 7, broadcast 5
The recommended setting would be 3
The setting for a EZ Drop Spreader by Republic at a rate of 3.4 lbs per 1,000 sq ft would typically be found in the spreader's manual or on the calibration chart. Generally, for this rate, you might expect to set the spreader at a medium to high setting, depending on the specific model and the type of material being spread. It's important to conduct a test run to ensure even distribution and adjust the setting as needed for optimal results. Always check the manufacturer's guidelines for the most accurate settings.
If you send an email to Scotts Consumer service they can actually send you the spreader settings you need. You can contact them through their website and they will email your spreader setting. https://www.scotts.com/smg/contactus/contactUs.jsp?navId=page900108&parentId=page900134