99% chance that you have a bad tail light socket. My local NAPA sells them, and they use different bulbs than what came in the car originally. The ground wires break off on these very easily inside the socket causing the issue.
Remove the tire and wheel from your 1994 Plymouth Sundance. Remove the brake assembly spring. The brake pads will come off. Reverse the process to install the new brakes.
Under the dash, driver seat side of the parking brake.
Master cylinder reservoir at driver's side firewall should have markings indicating full and low
it sounds like to me that your master cylinder might be bad
Remove the grease cap in the wheel center. Then remove the cotter pin, and finally the nut. The brake drum should slide off. Remove the grease cap in the wheel center. Then remove the cotter pin, and finally the nut. The brake drum should slide off.
Yes, but the buyer must be informed.
How about a malfunctioning brake light switch
A bad ground wire is the most common cause of turn signals and brake lights not working. The ground wire connection might be corroded.
probably your blinker switch (multi-accessory switch). The high mount brake light is wired directly from the switch on the pedal but the rear two lights are wired through the pedal switch and then through the the blinker switch on the steering column. Almost all of those blinker switches go bad.
Bad earth connection at light cluster?
when you flip your blinker on, a relay in the circuit is activated which turns the light on and off. also, the front blinker and rear blinker usually alternate in turning off and on, so when the back is on, the front will be off, and reverse.. that's why when a bulb is out, the clicking sound in the vehicle goes faster than when both are in working order.
Sounds like a problem with the switch in steering column
The GMC dash tail and parking lights are on a different fuse from the brake lights. Check the fuses for a possible blown fuse.
The tail lights are on a separate wiring than the blinker/brake lights. Look for a blown fuse or a broken/loose wire.
The 2002 Monte Carlo blinker flasher relay switch is located beneath the drivers side dashboard. The blinker flasher relay switch will be above the brake pedal.
Remove the tire and wheel from your 1994 Plymouth Sundance. Remove the brake assembly spring. The brake pads will come off. Reverse the process to install the new brakes.
Nonfunctional Brake LightsOne possible cause of this issue is that the brake light switch is not adjusted properly, or the switch could be defective.