0
What else can I help you with?
What happens to the flame if the air holes are open too much?
If the air holes are open too much, it can lead to an influx of oxygen that may cause the flame to burn too hot and inefficiently. This can result in increased fuel consumption, uneven heating, and even potential safety hazards. Adjusting the air holes to the correct setting helps maintain a steady and controlled flame.
How much noise does 600watt wind turbine make?
A 600-watt wind turbine typically generates around 45-65 decibels of noise, which is comparable to ambient noise in a quiet residential area. This noise level is considered low and is not usually disruptive to people in the vicinity.
Why a non luminous flame does not give out much light?
A non-luminous flame does not give out much light because it lacks sufficient heat to excite the molecules in the flame to emit visible light. The flame does not reach a high enough temperature to produce a glowing effect, resulting in minimal light emission.
How much noise does the average person make?
It's difficult to quantify the amount of noise an average person makes as it can vary based on individual habits and environment. In general, an average person might create noise levels ranging from 40 to 60 decibels during daily activities.
What is the noise ratio of the audio recording?
The noise ratio of an audio recording is the ratio of the signal (desired sound) to the noise (unwanted sound) present in the recording. It is a measure of how much unwanted noise is present compared to the desired sound.
What is the characteristics of a safety flame I have really hard homework and it say draw a safety flame and label the characteristics of this flame i have no idea what characteristics are?
I'm only in Yr 7 and i know,anyways the characteristics are what it contains a safety flame is when the flem is on and orangey colour and is not as hot as the blue flame.For example you are using a Bunsen burner (you gotta have used a Bunsen burner at least once at scholl cause i have,any ways the blue flame is always hotter than the orangey flame (the safety flame) because to make a blue flame you need to open the Bunsen burner jacket to let oxygen pass through.Sp the characteristics are that the safety flem is an orangey cour as oppsed o the blue flame,which is also much hotter than the safety flame.
What is another name for the safety flame?
A Safety Flame Is The Yellowy Orange Flame. It Is Called A Safety Flame Because You Can See It Unlike The Blue Flame
Why is the yellow flame the safety flame?
Yellow flame can be seen easily and it doens't produce much heat.
Why should you use the yellow flame when the Bunsen burner is unattended?
Safety. The yellow flame is easier to see and burns much less hot.
You make as much noise as?
A ... Cow..!!!
What if your steps make that much noise?
Then shhh.
Do kangaroos make noise?
Not much but they do make a noise. It's usually grunts, small barks and coughing noises.
What is 4 differences between a yellow safety flam and a blue heat flame produced by a Bunsen burner?
The blue flame is really hotter than the yellow flame. If you put your hand over a blue flame and skim through it, it would burn you but if you put it over a yellow flame it wouldn't burn you that much.
Will a cake collapse with too much noise?
Not that much... I mean, how much can it make?
Are there skateboard Wheels that dont make loud noise?
ITS NOT THE WHEELS!its the bearings.if you keep the shell on the bearing then it shouldn't make that much noise.
What is the amount of air mixing with gas on a Bunsen burner safety?
The amount of air mixing with gas on a Bunsen burner should be regulated to achieve the desired flame. Too little air can result in a yellow, sooty flame, while too much air can make the flame noisy and inefficient. It is recommended to adjust the air inlet to create a blue, non-luminous flame for safe and effective burning.
Why did the car make so much noise?
Because it is old
